BACCIO AC-513K Istruzioni per l'installazione
1
MULTI-CAPSULE COFFEE MAKER
USER GUIDE AND SAFETY INSTRUCTIONS
Model AC-513K
Please read this Users Guide and the safety instructions before operating this
BACCIO Multi-Capsule Coffee Maker!
2
Content
English ………………………………………………..…………………………….. 03
Español ……………………………………………..……………………….………. 17
Imported and distributed by:
Lat-Zero Coffee LATZECO S.A.S., Calle Caspicara S-19-88 y Pasaje Kingman,
Quito, Ecuador.
Manufactured by:
Foshan Shunde Stelang Electric Appliance CO. LTD., Junhe Road, Junan Town,
Shunde District, Foshan City, China
3
ENGLISH
Thank you for your purchase!
This coffee Multi-Capsules maker is manufactured with great care. If you take
proper care of it, it will reward you with many years of good service.
Before using your new maker, please read this Users Guide and its safety
instructions carefully.
Content
Safety Precautions
Important Tips
Notes on this Users Guide
Unpacking
Makers’ Controls and Parts
Getting Started
Filling the Water Tank
Purging the Internal Piping
Multi-Capsule and Coffee adaptors
Brewing Coffee
Coffee Flow Settings
Reset Factory Settings
Energy Saving Mode
Cleaning the Coffee Maker
Usage Warnings
Troubleshooting
Technical information
After Sales Service Information
4
Safety Precautions
Please take time to read these safety precautions carefully before
connecting your machine to the power supply.
- Danger of electric shock! Never immerse the machine in water or any
other liquid.
- Connect only to a properly grounded power point.
- Always pull out the power plug before:
o Relocating the maker.
o Cleaning or maintenance.
o Long periods of disuse.
- Never clamp or run the power cable over sharp corners or edges.
- Danger of electric shock! Damaged power cables may only be replaced
at the customer service center.
- Danger of electric shock! Never touch the power lug/socket/cable or the
maker with damp or wet hands.
- Never unplug by pulling out the power cable; always remove the plug.
- If you need an extension cable, make sure it is suitable for your maker
and lay the cable to avoid accidents.
- Danger of burning! Never move the maker during operation!
- Do not use the maker in case of:
o Faulty operation.
o Damaged power cable.
o After falling or other damage.
o In such cases immediately have the maker checked and repaired,
if necessary, at the customer service center.
- The maker must be located following requirements:
o Choose a dry, stable and leveled surface not immediately
underneath the power point. at least 60 cm away from the
washbasin and taps.
o Never place over flammable surfaces or equipment.
o Never place the maker or power cable within 50 cms from hot
surfaces.
o Never cover the maker during operation.
- Keep children away from the maker during operation.
- Only use the maker in dry rooms.
- Danger of tripping! Do not let the power cable hanging.
- Pull out the power plug and allow the machine to cool down completely
before cleaning and or maintenance.
- To prevent damage, never use replacement parts or accessories not
recommended by the manufacturer.
5
- If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent, or any qualified technician.
Important Tips
- Always make sure the level of water in water tank is above the minimum
level.
- Never touch the hot parts of the maker during and after operating (e.g.
brew unit during operations).
- Don’t touch the steam or water jets.
- Never move the maker while it is under use.
- The makers’ surface is subject to residual heat after use.
Notes on this Users Guide
This operating manual cannot cover all possible circumstances. For further
information or in case of problems not adequately covered in this operating
manual, please contact the service and sales center.
Unpacking
Remove your Baccio Multi-Capsule Coffee Maker from its package.
After unpacking, please check that the following parts are included:
1. Baccio Multi-Capsule Coffee Maker
2. Water tank
3. Manual
4. Three (3) coffee adapters
a. Adaptor for NespressoÒcapsules
6
b. Adaptor for Dolce GustoÒcapsules
c. Adaptor for grounded coffee powder
5. Coffee spoon
6. Air pump
Notes:
- Check that your home power supply voltage is the same as marked on
the machine rating plate
- Make sure that you don’t leave the plastic bags and other packaging
elements within reach of children
- You may find a little water remaining inside the maker. To ensure that
this maker works perfectly, it was tested with water before leaving the
factory.
Tip:
Keep the packaging for future mobilization of the maker
Makers’ Controls and Parts
7
Getting Started
Please consider that improper handling of electrical equipment might
dangerous and result in injuries. Make sure you checked the Security
Precautions section in this Users Guide
Before using your Baccio Multi-Capsule Coffee Maker for the first time or after
long periods of disuse, make sure to purge the internal piping.
Filling the Water Tank
There are two ways of filling the water tank: directly into the machine, by using
for example a jug, or by removing the water tank.
Filling without removing the water tank:
Filling by removing the water tank
1. Raise the water tank cover.
2. Fill the tank with cold fresh water.
3. The maximum capacity is 0.6 liters.
4. Low down the tank cover
1. Hold the water tank at a tilting angle and
pull to remove the tank from the maker
2. Fill the tank with cold fresh water.
3. The maximum capacity is 0.6 liters.
4. Slide the water tank slowly on its base,
when the water tank outlet is inserted in
the inlet receptacle, push firmly on the
water grip to lock.
8
Purging the Internal Piping
3. Connect the power supply
4. Press the Power Button and wait until the
lights of the three buttons stop flashing; it
means that the maker is heated and ready to
work (heating process takes approximately 45
seconds)
5. Before purging make sure that:
- The brewing basket is closed with no
capsule inside
- The water tank is full and properly placed
- You’ve placed a liquid container (250 ml)
under the coffee dispenser to contain the
purged liquid
6. Press the Lungo Coffee button (right button) to
start purging and wait until the maker stops
flushing automatically. The purging process is
finished.
9
Multi-Capsule and Coffee Adaptors
10
Brewing Coffee
1. Open the makers’ handle.
2. Pull out the brewing basket.
3. Choose a brewing basket
4. Insert the desired capsule or coffee powder
7. Place a cup and press the power button.
8. Wait until all three buttons stop flashing. The
warming process might take 20 seconds
approximately.
9. Press the selected cup button (Espresso – left
or Lungo – right)
10. Wait until brewing process is over: espresso
might take around 25 seconds and lungo
around 47 seconds.
For NespressoÒor Dulce GustoÒ
compatible capsules, insert capsule
as shown in the following graphics
For grounded coffee powder, fully fill
the adaptor’s container and press
tightly. Pressing properly is important
to ensure a good brewing and a good
taste
5. Insert the brewing basket with the capsule or
coffee powder into the maker.
6. Close the handle
Indice
Lingue:
