Baitstar Xpert Manuale tecnico
BaitStar Xpert
GPS Operation Instruction
!Gouden voerboot regels!
1. Een voerboot is een hyper modern apparaat voorzien van zeer geavanceerde,
gevoelige electronica en onderdelen dus behandel hem ten allen tijden met
de grootst mogelijke zorg en voorzichtigheid!
2. Vaar nooit achteruit met je boot wanneer er een rig in ligt,
hierdoor heb je kans dat de lijn achter de boot in de propeller komt met alle
gevolgen van dien.
3. Zet je boot NOOIT onnodig in de volle zon, regen of kou!
4. Lucht je boot regelmatig door de kap iets te openen zodat condens kan
ontsnappen (minimaal na elke sessie maar lieft zo vaak mogelijk)!
5. Pas op met het neerzetten van je boot zet deze het liefst op een dun (onthaak)
matje
6. Zet je boot altijd droog en schoon weg!
7. Bevestig een nekkoord aan je handzender en hang deze om je nek tijdens
gebruik
8. Zorg altijd voor (nagenoeg) volle accu’s voordat je gaat vissen
9. Zet je boot nooit weg voor langere tijd met lege accu’s!
10. Vang een paar mooie bakken!
Houdt je bovenstaande regels in acht dan zul je Jarenlang plezier van je boot hebben
en zal deze je heel veel mooie vissen gaan opleveren!
User Instruction:
I. Product introduction
1. Product introduction
Parameters of the BaitStar Xpert Intelligent Bait Boat:
Basic
parameters
Boat
parameters
Product model: BaitStar Xpert
Dimension: 65cm (L) * 37cm (W) * 25cm (D)
Net weight: 4.5kg
Maximal loading: 3kg
Bait hopper dimension: 24cm (L) * 15cm (W) * 13cm (D)
Boat material: high-quality ABS engineering plastics
Wireless
performance
5.8GHz anti-interference remote controller
500m remote control distance
Bait casting
and hook
dropping
2 independent bait hoppers (opened separately under control)
Wearing-free electromagnet bait casting and hook dropping system.
Product
performance
Two sets of lithium batteries (12V13AH) with 5-hour duration
Imported high-performance high-torque ultra-silence motor
Waterproof design of the whole boat
Double boat body design and resistance to Class 5-6 storm
Double motor driving, best operation and control performance and
ability to turn around in any situation
Stepless speed change and maximum operation rate of 120m/min
Front white and rear blue ultra-bright LED lamp
Protective system resistant to waterweeds and fish line winding
Reserved fish finder and GPS navigation installation port
Reserved bait thrower, Charging voltage of AC220 for boat charger
1. Introduction to the GPS automatic driving function
1-1 Operation notices of GPS automatic driving function
（1）About 5-10 min after startup, the satellite signals will be stable.
When 10 satellites are available, the automatic driving function can be
enabled. When more than 15 satellites are available and the boat is located
in an open area without any obstacle, the positioning precision can reach
about 1m.
（2）Every time the boat arrives at the fishing place, please first set the
origin to ensure that the boat can automatically return to the origin in case
of an emergency. It is recommended to set the origin at the water surface
several meters away from the bank. The automatic driving function shall be
enabled at the origin. The bow shall point to the extensive water surface as
much as possible to prevent the boat from stranding on the bank during
automatic steering.
（3）Before the automatic driving function is used, the double-motor
speed adjustment knob shall be manually adjusted to make the boat advance
without deviation on the still water surface. The double knobs for motor
speed adjustment shall be adjusted to the maximum clockwise. When the
boat deviates to the left in sailing, the right knob shall be slowly adjusted
anticlockwise, vice versa.
（4）When the boat cannot receive the signals from the remote
controller or the boat power reduces to the minimum warning value, the
boat will automatically enable the returning function and return to the
origin. The right stick shall be located on the middle position in automatic
return. Otherwise, it will interfere with normal return. Four lamps will
continuously flicker in automatic return.
（5）When the power of the remote controller is consumed up or the
remote control function fails, please turn off the power of the remote
controller. The boat will automatically enable the returning function and
return to the origin after 7s. Four lamps will continuously flicker in
automatic return.
（6）When the boat power reduces to about 30%, the red power
indicator of the boat will be on and you can continue using the boat for about
15 min. When the power reduces to about 20%, the remote controller will
give out the power alarm and the red power indicator of the boat will begin
to flicker. At this time, the boat may enable automatic returning function in
case of lower power. You shall stop using the boat immediately and charge
it.
（7）The remote controller shall be powered by high-quality AA-sized
batteries such as GP or Duracell or high-capacity AA-sized charging
batteries. When the power of the remote controller reduces to 30%, the
power alarm will be given out. When the power reduces to be under 20%,
please change the batteries of the remote controller in time. In addition,
always make sure that the remote controller has enough spare batteries for
use at any time. Otherwise, when the power of the remote controller is
consumed up, the boat cannot be controlled and an emergency will occur.
（8）Before the GPS automatic driving function is enabled, please make
the right stick located on the middle position. Manual operation is always
dominant in automatic driving. When you operate the right stick or press
“Exit” key during this period, the automatic driving program will terminate
and the boat will switch to the manual operation mode.
（9）To ensure that the boat keeps within the valid coverage during
sailing the longest distance of the GPS automatic driving is 300m. The
automatic return is not restricted in case of an emergency.
（10）If the automatic driving cannot keep the correct direction in the
stormy weather, please switch to the manual navigation mode.
3-2 Operation introduction to GPS automatic driving
3-2-1 Operation instruction for remote controller of GPS automatic driving is as
follows
LCD
Left motor speed adjustment
Bait thrower switch (low
speed/high speed)
Lamp switch
Tail
right hopper
Turn left
Turn right
Back right
Back left
Back
Front
Turn
left at
origin
Turn
right at
origin
Left
bait
hopper
Right
bait
hopper
Tail left hopper
Hook device
Reset button
Down key
Power switch
Right motor speed adjustment
OK key
Cancel
key
Up key
3-2-2 Operation menu of GPS function is as follows
（1） Startup homepage: The startup homepage includes the satellite quantity,
power of remote controller and boat power percentage. The sailing
direction will be displayed in real time at the left up corner and the signal
strength of the remote control will be displayed at the right up corner.
（2） Electronic compass correction for startup: To ensure correct orientation
of the bow at the top left corner of the homepage, please calibrate the
electronic compass as follows:
Homepage (OK key) →calibrate terrestrial magnetism (OK key) →
horizontally rotate the remote controller by one round (OK key)
→vertically rotate the remote controller by one round (OK key.
Press Exit key and return to the homepage)
（3） Set the origin: After the boat arrives at the fishing field, first set the
origin as follows:
Homepage (down key) → origin homepage (hold Ok key) → prompt
to select “OK” →Save successfully (set the origin successfully)
（4） Position point saving function and manual and automatic function:
When any position point is saved, the manual function indicates to
arrive at the position point via manual operations on the graphic
navigation. The automatic function indicates to automatically drive the
boat to the position point. Operations are described as follows:
Homepage (hold Down key) → page at any position point (OK key)
→ select manual or automatic (Hold the OK key) → enable manual
or automatic function
The manual operation images are introduced as follows:
（5） View the real-time distance of the boat from the origin. This function is
operated as follows:
Homepage (up key) → Display of information such as distance from
the origin
2. Battery charging
（1）Charge the boat battery pack by using the charger
The original 12.6V/5A charger shall be used to charge the boat battery pack.
Keep the boat power off in charging. The charger indicator is red in charging. After the
battery pack is fully charged, the charger indicator becomes green.
Charging Method: Please take out two battery packs from the boat battery
compartment, connect the original shunt current line to the charger, connect two ends
of the shunt wire to two battery packs, and charge them simultaneously.
Simultaneously charge two battery packs with the charger for about 7-8 hours.
When only one battery pack is charged, the duration will reduce by half.
Indice
Altri manuali Baitstar Barca
Manuali Barca popolari di altre marche
PURSUIT
PURSUIT OS 335 Manuale utente
Boston Whaler
Boston Whaler CONQUEST 345 Manuale utente
Jeanneau
Jeanneau SUN ODYSSEY 41 DS Manuale utente
Meridian
Meridian 490 Pilothouse Manuale utente
Advanced Elements
Advanced Elements AdvancedFrame Expedition AE1009 Manuale utente
Robo Marine Indonesia
Robo Marine Indonesia GEOMAR Manuale utente
