Ceiling mounted
cameras, ip
image vertically
from button.
Image settings
can be
adjusted using
the camera
controls on the
stand alone
camera page.
You can receive
notications on
motion and/or
sound detection
and adjust the
sensitivity.
Select:
Settings ->
Devices ->
Your Camera
Manage ->
Detection Settings
CAMERA DETAIL
RESET THE CAMERA
To restore the camera back to factory settings:
1. Hold the Reset button for about 10 seconds with
the camera powered on.
2. Release the button and wait about 30 seconds.
The camera will automatically restart, and restore
factory settings.
CHANGE WI-FI NETWORK
First, setup the Smart Hub on the new network and
then:
1. Open the Smart Hub phone app and remove the
camera from the Smart Hub.
2. Reset the camera using the instruction above.
3. Re-follow the instructions “Adding the Camera”.
FOR WPS SETUP
To use WPS to connect your Camera to your home
network, hold the ‘WPS’ button on the back of the
camera for 2 seconds and then press the WPS
button on your Wi-Fi router within 60secs.
NOTE - Your router must have WPS enabled (refer to
the routers user manual)
After WPS has successfully completed, proceed with
the “Adding the Camera”instructions.
CONFIGURE THE CAMERA
STEP EIGHT
tip
Check out the HELP menu on the home page in the
APP for more instructions
FOR WIRED CONNECTIONS
To connect the Camera to your home network using
a wired connection, connect the Camera to your
router using the Ethernet cable before you follow
the “Adding the Camera”instructions.
1
LAN
WPS/Reset
Power
Power light/
Network light
Micro SD Card Slot
Microphone
Lens
Magnetic Bracket
refer to bnd.com.au for full warranty details.
