Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
page 6
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
creating
inspections
Inspection Work Flow
step 7
step 7
Software Setup
Use the Main Menu toolbar to navigate the PresencePLUS Pro options. Proceeding from left to
right, the buttons in the Menu toolbar step through the process of creating an inspection file.
Set up the camera, lens, and lighting, to acquire a reference image.
a. Set up the camera lens and lighting.
b. Choose Trigger option Continuous for a live image.
c. Click Auto Exposure to adjust the brightness.
d. Focus the lens on the camera by turning the lens until the Focus
Number is maximized.
e. When you have the desired image, click Next to proceed to the Tools
screen, this will acquire the reference image.
Add tools to the inspection. Build the tools from scratch or add tools from
a previous inspection file saved on the PC or controller. To add a vision
tool, click the Tool button. To remove a tool, click the “X” in the lower left-
hand corner of the screen.
a. Add Location Tool(s) to find the target to adjust the following Regions
of Interest (ROI) for transitional and rotational changes.
b. Add Vision Tool(s) to inspect the part.
c. Add Measure Tool(s) to create distance measurements from points
found.
d. Add Test Tool(s) to set the Pass/Fail criteria. (The Vision and Measure
Tools are inputs to the Test Tool.)
e. Click Quick Teach to automatically set all the selected parameters in the
Test Tool and proceed to the Run screen, or click Next to proceed to
the Teach screen, to teach a sample set of good products.
NOTE: If you want to keep parameters in a test tool, skip Teach and go
directly to Run.
1.
2.
creating
inspections
TIPS
TIPS
Before creating an
inspection file, set
up the electrical
configuration of
the external
trigger. (Click
System button,
select Trigger tab.)
Required
Required
