Baofeng UV-5R Series Manuale utente
DUAL BAND FM Transceiver
UV-5R
OPERATING MANUAL
FCC ID: 2AN62-UV5R
SAIN3 LLC
PREFACE
Thank you for purchasing UV-5R Amateur Portable Radio, which is a dual band/dual display radio.
This easy-to-use radio will deliver you secure, instant and reliable communications at peak
efficiency. Please read this manual carefully before use. The information presented herein will help
you to derive maximum performance from your radio.
CONTENT
1.-SAFETY INFORMATION
2.-FEATURES AND FUNCTIONS
3.-UNPACKING AND CHECKING EQUIPMENTS
4.- OPTIONAL ACCESSORIES
5.- INSTALLATION OF ACCESSORIES
5.1.- INSTALLING THE ANTENNA
5.2.- INSTALLING THE BELT CLIP
5.3.- MICRO-HEADSET INSTALLATION OF EXTERNAL
5.4. –BATTERY INSTALLATION
6.-BATTERY CHARGING
7.-BATTERY INFORMATION
7.1.-INITIAL USE
7.2.-BATTERY TIPS
7.3.-PROLONG BATTERY LIFE
7.4.-BATTERY STORAGE
8.-PARTS, CONTROLS AND KEYS
8.1.-RADIO OVERVIEW
8.2.- COMMAND/KEY DEFINITION
9.-‘LCD’ DISPLAY
10.- 1750 Hz TONE FOR ACCESS TO REPEATERS
11.1.-RADIO ON-OFF/VOLUME CONTROL
11.2.- SELECTING A FREQUENCY OR CHANNEL
12-ADVANCED OPERATION
12.1.-SET MENU DESCRIPTION
12.2.-SHORTCUT MENU OPERATION
12.3.-“SQL”(SQUELCH)
12.4.-FUNCTION “VOX”(VOICE OPERATED TRANSMISSION)
12.5.- SELECT WIDEBAND OR NARROW BAND “W/N”
12.6.-TDR (DUAL WATCH/DUAL RECEPTION)
12.7.- TOT(TRANSMISSION TIMER)
12.8.-CTCSS/DCS
12.9.- ANI
12.10.- DTMFST (DTMF TONE OF TRANSMITTING CODE )
12.11.- SC-REV(SCAN RESUME METHOD)
12.12.- PTT-ID(PTT OR RELEASE PTT TO TRANSMIT THE SIGNAL CODE)
12.13-BCL(BUSY CHANNEL LOCKOUT)
12.14.- SFT-D(DIRECTION OF FREQUENCY SHIFT)
12.15.- OFFSET(FREQUENCY SHIFT)
12.16.-STE(STE TAIL TONE ELIMATION)
13.-CTCSS TABLE
14.-DCS TABLE
15.-TECHNICAL SPECIFICATION
15.1.-GENERAL
15.2. –TRANSMITTER
15.3. - RECEIVER
16.-TROUBLESHOOTING
17.-WARRANTY
1.-SAFETY INFORMATION:
The following safety precautions shall always be observed during operation, service and repair of this equipment.
◇This equipment shall be serviced by qualified technicians only.
◇Do not modify the radio for any reason.
◇Use only SAIN3 LLC supplied or approved batteries and chargers.
◇Do not use any portable radio that has a damaged antenna. If a damaged antenna comes into contact with
your skin, a minor burn can result.
◇Turn off your radio prior to entering any area with explosive and flammable materials.
◇Do not charge your battery in a location with explosive and flammable materials.
◇To avoid electromagnetic interference and/or compatibility conflicts, turn off your radio in any area where
posted notices instruct you to do so.
◇Turn off your radio before boarding an aircraft. Any use of a radio must be in accordance with airline
regulations or crew instructions.
◇Turn off your radio before entering a blasting area.
◇For vehicles with an air bag, do not place a radio in the area over an air bag or in the air bag deployment area.
◇Do not expose the radio to direct sunlight over a long time, nor place it close to heating source.
◇When transmitting with a portable radio, hold the radio in a vertical position with the microphone 3 to 4
centimeters away from your lips. Keep antenna at least 2.5 centimeters away from your body when transmitting.
WARNING: If you wear a radio on your body, ensure the radio and its antenna are at least 2.5
centimeters away from your body when transmitting.
2.-FEATURES AND FUNCTIONS:
-Dual-band handheld transceiver with display function menu on the display "LCD".
- DTMF encoded.
- Commercial FM radio receiver (65 MHz ~ 108 MHz).
- Incorporates 105 codes "DCS" and 50 privacy codes "CTCSS" programmable.
- Function "VOX" (voice operated transmission).
- Alarm function.
- Up to 128 memory channels.
- Broadband (Wide) / Narrowband (Narrow), selectable.
- High power / low (5 W/1 W) selectable.
- Display illumination and programmable keyboard.
- Function "beep" on the keyboard.
- Dual Watch/dual reception .
- Selectable Frequency Step 2.5/5/6.25/10/12.5/25 kHz.
- Function "OFFSET" (frequency offset for repeater access).
- Battery saving function "SAVE".
- Timer transmission "TOT" programmable.
- Selecting the Scan Mode.
- Function Busy Channel Lock "BCLO".
- Built-in RX CTCSS/DCS scan
- Built-in LED flashlight.
- Programmable by PC.
- Level Threshold "Squelch" adjustable from 0 to 9.
-Crossband reception/transmission
-Tone end of transmission
- Built-in key lock
3.-UNPACKING AND CHECKING EQUIPMENTS:
Carefully unpack the transceiver. We recommend that you identify the items listed in the following
before discarding the packing material. If any items are missing or have been damaged during
shipment, please contact your dealers immediately.
Note:
-Items included in the package, may differ from those listed in the table above depending
on the country of purchase. For more information, consult your dealer or vendor.
4.- OPTIONAL ACCESSORIES:
Note:
- Consult the dealer or retailer for information about options available.
5.- INSTALLATION OF ACCESSORIES:
5.1.- INSTALLING THE ANTENNA:
Install the antenna as shown in the figure below and turn it clockwise until it stops.
Note:
- When installing the antenna, don’t rotate it by its top,
holding it by its base and turn.
- If you use an external antenna, make sure the ‘SWR’ is
about 1.5:1 or less, to avoid damage to the transceiver's
final transistors.
- Do not hold the antenna with your hand or wrap the outside
of it to avoid bad operation of the transceiver.
- Never transmit without an antenna.
5.2.- INSTALLING THE BELT CLIP:
If necessary, install the belt clip at the rear of the battery compartment cover as
shown in the figure below.
Note:
- Do not use any kind of glue to fix the screw on the belt clip.
The solvents Glue may damage the battery casing.
5.3.- MICRO-HEADSET INSTALLATION OF EXTERNAL:
Plug the external micro-headset connector into the jack of ‘SP. & MIC’
of the transceiver as shown in the figure below.
5.4. –BATTERY INSTALLATION:
-When attaching the battery, make sure the battery is in parallel and in good contact with the
aluminum chassis. The battery bottom is about 1 to 2 centimeters below the bottom of the radio’s
body.
-Align the battery with the guide rails on the aluminum chassis and slide it upwards until a ‘click’is
heard.
-The battery latch at the bottom locks the battery.
-Turn off the radio before removing the battery.
-Slide the battery latch, at the bottom of the radio’s body, in the direction indicated by the arrow.
-Slide down the battery for about 1 to 2 centimeters, and then remove the battery from the radio’s
body.
6.-BATTERY CHARGING:
Use only the charger specified by the manufacturer. The charger’s LED indicates the charging
progress.
CHARGING STATUS LED INDICATION
Standby (no-load) Red LED flashes,while Green LED glows
Charging Red LED solidly glows
Fully Charged Green LED solidly glows
Error Red LED flashes,while Green LED glows
Please follow these steps:
1. Plug the power cord into the adapter.
2. Plug the AC connector of the adapter into the AC outlet socket.
3. Plug the DC connector of the adapter into the DC socket on the back of the charger.
4. Place the radio with the battery attached, or the battery alone, in the charger.
5. Make sure the battery is in good contact with the charging terminals. The charging process
initiates when the red LED lights.
6. The green LED lights about 4 hours later indicating the battery is fully charged. Then remove the
radio with the battery attached or the battery alone from the charger.
7.-BATTERY INFORMATION:
7.1.-INITIAL USE
New batteries are shipped uncharged fully from the factory. Charge a new battery for 5 hours
before initial use. The maximum battery capacity and performance is achieved after three full
charge/discharge cycles. If you notice the battery power runs low, please recharge the battery.
WARNING: -To reduce the risk of injury, charge only the battery specified by the manufacturer. Other batteries may
burst, causing bodily injury and property damage.
-To avoid risk of personal injury, do not dispose of batteries in a fire!
-Dispose of batteries according to local regulations (e.g. recycling). Do not dispose as household waste.
-Never attempt to disassemble the battery.
7.2.-BATTERY TIPS:
1. When charging your battery, keep it at a temperature among 5℃- 40℃. Temperature out of the
limit may cause battery leakage or damage.
2. When charging a battery attached to a radio, turn the radio off to ensure a full charge.
3. Do not cut off the power supply or remove the battery when charging a battery.
4. Never charge a battery that is wet. Please dry it with a soft cloth prior to charge.
5. The battery will eventually wear out. When the operating time (talk-time and standby time) is
noticeably shorter than normal performance, it is time to buy a new battery.
7.3.-PROLONG BATTERY LIFE:
1. Battery performance will be greatly decreased at a temperature below 0℃. A spare battery is
necessary in cold weather. The cold battery unable to work in this situation may work under room
temperature, so keep it for later use.
2. The dust on the battery contact may cause the battery cannot work or charge. Please use a
clean dry cloth to wipe it before attaching the battery to the radio.
7.4.-BATTERY STORAGE:
1. Fully charge a battery before you store it for a long time, to avoid battery damage due to
over-discharge.
2. Recharge a battery after several months’ storage (Li-Ion batteries: 6 months), to avoid battery
capacity reduction due to over-discharge.
3. Store your battery in a cool and dry place under room temperature, to reduce self-discharge.
8.-PARTS, CONTROLS AND KEYS:
8.1.-RADIO OVERVIEW:
Altri manuali per UV-5R Series
14
Indice
Altri manuali Baofeng Ricetrasmettitore
Baofeng
Baofeng UV-82 Manuale utente
Baofeng
Baofeng UV-5R Series Manuale utente
Baofeng
Baofeng UV-3R Manuale utente
Baofeng
Baofeng UV-5RA Manuale del proprietario
Baofeng
Baofeng UV-5R Series Manuale utente
Baofeng
Baofeng UV-2501 Manuale utente
Baofeng
Baofeng UV3RPLUS Manuale utente
Baofeng
Baofeng UV-5RV2+ Manuale utente
Baofeng
Baofeng UV-5R Series Manuale utente
Baofeng
Baofeng UV-5R Series Manuale utente
