Barracuda M40B Manuale utente

Page 1

Barracuda 4G USB MODEM M40B - Quick Start Guide

Thank you for purchasing the Barracuda 4G USB modem for Barracuda CloudGen Firewall that conveniently provides support for wireless broadband communication technologies. The modem supports bandwidths up to 1.2 Gbps

downstream and 150 Mbps upstream to provide a cost eective alternative to xDSL and ISDN uplinks or failover lines. Note: SIM card is not included and has to be obtained independently through your internet service provider.

Package Content:

• One USB Modem

• One USB Cable

• Two External Antennas

• Quick Start Guide

Please contact Barracuda Technical Support if any of these items is missing.

1. USB Interface

2. Secure screw (Torx size T9)

3. Secure plate

4. SIM card location

5. SMA antenna interface

6. Power LED (Blue)

7. Network status LED (Green)

Status LED:

The modem is equipped with a network status LED that indicates the operational

state by changing between

o, slow blinking, and fast blinking. The table below shows the dierent meanings of the glowing states:

Getting Started

1. Open the secure plate with a T9 Torx screwdriver. Insert the micro SIM card as illustrated on the modem

until it gets locked. To remove the micro SIM card, carefully press on the micro SIM card until it unlocks

and slides out of the bay.

2. Connect the modem to a free USB port on your Barracuda CloudGen Firewall by using the included USB

extension cable.

Note: The rewall appliance needs to be powered o, as otherwise the modem driver will

not be initialized.

3. Connect the external antennas to the ANT 1 and ANT 2 interfaces of the modem. The external antennas

are equipped with a magnetic base thus allowing for convenient placement on racks or any other metal

surfaces.

4. Deploy the modem with a standard cap rail.

5. Power on the Barracuda CloudGen Firewall and modify the WWAN network settings by navigating to

Conguration > Network > Wireless WAN.

6. Set Enable WWAN to Yes.

7. Select the Modem type.

8. Enter the Access Point Name of the provider (available from the provider).

9. Enter the SIM PIN number (if PIN needed).

10. Enter the Phone Number for dial-in (available from the provider).

11. To activate the conguration, click Send Changes followed by Activate.

LED State/Cycle Output Meaning

OFF OFF

GREEN ON - 100ms

OFF - 2s Registered 2G network

GREEN

ON - OFF

50ms; 2 times

OFF - 2s

Registered 3G/4G network

Page 2

Barracuda 4G USB MODEM M40B - Quick Start Guide

12. Go to CONTROL > Box, expand the Network section and click Activate new network conguration.

Click Failsafe in the appearing Network Activation pop-up window. Wait for the Activation Succeeded

dialog, and then click OK.

Note: Due to network activation you may lose connection to the appliance. Select Reconnect (upper

right) to reconnect.

13. Navigate to CONTROL > Network and check the availability of the WWAN uplink (ppp5)

14. In order to restart, switch-o, or stop the WWAN connections, navigate to CONTROL > Box >

Dynamic Networks.

For further details and product documentation, please visit: https://campus.barracuda.com

Barracuda Networks, Inc. 3175 S. Winchester Blvd, Campbell, CA 95008 USA • phone: 408.342.5400 • fax: 408.342.1061 • www.barracuda.com Copyright 2004-2023© Barracuda Networks, Inc. All rights reserved. Use of this product and this manual is subject to license. Information

in this document is subject to change without notice. Barracuda Backup is a trademark of Barracuda Networks, Inc. All other brand and product names mentioned in this document are registered trademarks or trademarks of their respective holders. 11012023 v.40

Specication M40B

Frequencies (MHz)

• LTE FDD: B1, B3, B25(B2), B66(B4), B26(B5/B18/B19), B7, B8, B12(B17), B13, B14(FirstNet), B20,

B28, B29, B30, B32, B7

• LTE TDD: B38, B39, B40, B41, B42, B43, B46, B48 (CBRS/OnGo)

• 3G B1, B2, B4, B5(B19), B8, B9

WCDMA/HSDPA/HSUPA

Power Class

GSM/GPRS (GMSK) Power Class

• Power Class 4 (33 dBm) for GSM/E-GSM bands

• Power Class 1 (30 dBm) for DCS/PCS bands EDGE (8-PSK) Power Class

• Power Class E2 (27 dBm) for GSM/E-GSM bands

• Power Class E2 (26 dBm) for DCS/PCS bands

WCDMA/HSDPA/HSUPA Power Class

• Power Class 3 (24 dBm) for UMTS/HSDPA/HSUPA mode

LTE Power Class

• Power Class 3 (23 dBm) for LTE mode

Data Rate

• Data only module

• LTE Cat. 18 3GPP Rel. 12 - Up to 1.2 Gbps DL w/4x4 MIMO +3 CA

• HSDPA Cat 24, HSUPA Cat 8

SIM Interface 3VDC 6 pin

Power Supply 5 VDC via USB Interface

USB Interface Micro USB 2.0

Dimensions (LxWxH mm) 77 x 54.5 x 20.8

Net Weight (g) 150

Operation Temperature -10°C to +60°C

Certications

FCC / IC / CE / C-Tick

FCC / IC, PTCRB 9 (North America)

FCC Part 96 CBRS (USA)

CE, GCF (Europe)

AU IC-Tick (Australia)

Antenna

Interface SMA

Frequency Range (MHz) 824 - 960; 1710 - 2170

Input Impendence (Ohm) 50

Gain (dBi) 3.5

Polarization Type Linear, Vertical

Radiation Direction Omnidirectional

VSWR <3.5

Length (mm) 111

Cable Length (mm) 1000

Altri manuali Barracuda Modem

Barracuda

Barracuda M11 Manuale utente

Manuali Modem popolari di altre marche

Davicom

Davicom DM562AP Manuale utente

EpiValley

EpiValley TATA indicom SXC-1080 Manuale utente

Zte

Zte WiMAX Manuale utente

Intelimax

Intelimax MA-2060 Manuale utente

SMC Networks

SMC Networks D3CM1604V Manuale per l'uso e la cura

Telstra

Telstra Wi-Fi 4G Advanced Pro X Manuale utente

Thrane&Thrane

Thrane&Thrane imarsat EXPLORER 300 Manuale utente

Samsung

Samsung AceLink SAM-335A Manuale utente

Enfora

Enfora Enabler-G Guida rapida alla configurazione

iRZ

iRZ ATM2-232 Manuale utente

Zhone

Zhone 6310 Manuale utente

Paradyne

Paradyne Hotwire 7976 Manuale utente

US Robotics

US Robotics 3453C Manuale utente

MaxTech

MaxTech Plug & Play Internal Voice/FAX/Data/SVD... Manuale utente

Zte

Zte MF823 Manuale utente

Four-Faith

Four-Faith F1403 Manuale utente

Sierra Wireless

Sierra Wireless AIRLINK MP595W Manuale utente

Gemtek

Gemtek WiMAX WIXFBR-103 Manuale utente