Basalte ASANO P4a Manuale utente
Installation Manual
ASANO P4a
© 2018
basalte v1.0
1Power supply (230V AC)
2Loudspeaker output
a Zone 1
b Zone 2
c Zone 3
d Zone 4
3Analogue input
a Source 1
b Source 2
c Source 3
4Audio network
5Cooling Fan
6Service
Before operating the unit, please read this
manual thoroughly and retain it for future
reference.
Model No. 700-14
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate
this equipment.
Description
Asano P4a is a networked 4-zone amplifier, each zone output powered with 2x125 W amplifiers. It can connect 3
analogue audio input sources.
Asano P4a can only be used in combination with S4. The S4’s integrated KNX control allows you to integrate the Asano
P4a in a KNX system.
LED feedback
The Asano P4a front panel has a feedback LED which indicates following statuses:
• Blue: standby mode
• White: at least one output zone amplifier is active.
• Red flashing: device failure detected related to power supply or amplifier.
• Purple flashing: digital clipping or issues with the audio network.
1
2
4
3 6 3 2
c d
5
c
Installation Manual
ASANO P4a
© 2018
basalte v1.0
How to install
1 Dedicated audio network
Connect Asano P4a to the audio network using Ethernet
CAT5e cable. The network has to be a dedicated network
separated from your local data network.
2 Inputs
There are 3 analogue stereo inputs available. The
analogue inputs can be connected through RCA
connectors, both le (white colour) and right (red colour)
for stereo.
3 Loudspeaker outputs
The 4 amplified zone outputs need to be connected on a
separate connector per zone.
The connectors are dismountable from the unit. Each
cable can be connected through screw terminals allowing
a cable connection up to 2.5mm².
4 Bridged mode
The outputs of the P4a can be used in bridge mode. This
mode is used to combine the power of the le and right
channel delivering 450W at 4Ohm for each bridged output.
Bridged gives a choice between bridged (L + R), mono
bridged le and mono bridged right.
5 Power supply
The Asano P4a has to be powered by a Euro mains power
lead with a 230V AC input.
Do not unplug the connector at this side with voltage
present.
Technical data
Power: 220V - 240V AC
Analog input sensitivity: 2 V RMS
Minimum loudspeaker load: 3 Ohm
Speaker output power at 4 Ohm: 8 x 125W
Bridged output power at 4 Ohm: 4 x 450W
Ambient temperature:
Operation: -5°C to 45°C
Storage: -15°C to 55°C
Transport: -15°C to 55°C
Dimensions: w 430 x h 66 x d 265 mm
Weight: 6,2kg
Max. humidity: 93% relative humidity, no moisture
condensation
Protection class: II
Type of protection: IP 20
Certification: CE
basalte bvba | hundelgemsesteenweg 1A | 9820 merelbeke | belgium
L+ L- R- R+Normal: L+ L- R- R+
Bridged:
How to start up
Once correctly installed and powered, the Basalte Studio tool has to be used to configure the P4a.
Questo manuale è adatto per i seguenti modelli
1
Altri manuali Basalte Amplificatore
