Page 4
X Series DSP Cameras Installation Instructions
CAUTIONS
In order to avoid damaging your camera, note t e following points.
1) T e camera as t readed mounting points on t e top and bottom of t e case.
Only use a standard, p otograp ic mounting bolt wit a 1/4-20 UNC t read.
2) Before fitting t e lens, make sure t at its back will not touc t e CCD sensor or
associated components w en screwed fully ome.
3) Do not touc t e image surface of t e sensor. If t e sensor is accidentally
touc ed, only clean it using isopropanol.
4) Do not expose t e sensor to direct sunlig t as t is may impair t e performance
of t e camera.
POWER SUPPLY
Baxall X series cameras are available in AC mains and AC and DC low voltage ty es. T e
voltage required to operate t e camera is clearly marked on t e rear panel of t e
camera. The green POWER LED on the rear anel indicates that ower is connected. Only
power low voltage cameras from a class 2 isolated power supply. The ower
consum tion of a Baxall X series camera is less than 5 Watts.
Mains power supply
Cameras that are intended to o erate directly from the mains su ly are fitted with a non-
detachable ower su ly cord. The voltage of o eration is clearly marked on the rear anel of
the camera. Generally this is 98 - 260V AC at 50Hz. REFER TO THE WIRING INSTRUCTION
LABEL ATTACHED TO THE SUPPLY CORD and terminate the cord with the a ro riate mains
lug fitted with a 3A fuse. MAINS CAMERAS MUST BE CONNECTED TO A PROTECTIVE
EARTH. Ensure that a secure means of isolation from the mains is rovided for the camera in
accordance with the national wiring regulations of the country of installation.
Auto-switc ing power supply
Cameras fitted with an automatic selecting ower su ly o erate between 11-40V DC and
12-30V AC. Connections and olarity are indicated above the screw terminals on the rear
anel. T e power supply must be a class 2 isolated type.
VIDEO CONNECTIONS
To obtain a video out ut, connect a video coaxial cable terminated with a 75W BNC connector
to the BNC socket marked VIDEO OUT on the rear of the camera.
On selected cameras, a means of external synchronisation may be rovided - see the table on
age 2 for details. For external synchronisation, connect a video coaxial cable terminated with
a 75W BNC connector to the socket marked GENLOCK on the rear of the camera. The GENLOCK
facility synchronises to either a 1V eak-to- eak video signal or a standard sync lus blanking
signal. A signal connected to the GENLOCK in ut automatically overrides all other synchronisation
settings.
On colour cameras, the genlock facility locks the lines and not the subcarriers together.
