BEA LPS-A6 Manuale utente
INSTALLATION GUIDE
INSTALLING THE LPS-A6 POWER SUPPLY MO-
DULE IN THE EVERSOLO DMP-A6 / DMP-A6
MASTER EDITION
Tools required:
• LPS-A6 power supply kit
• EverSolo DMP-A6 / DMP-A6 Master Edition
• Phillips screwdriver
• Allen key 2.0mm
Step 1: Use a 2.0mm allen key to unscrew the 6 screws on the rear panel and the 7
screws on the underside of the unit. Total screws to remove: 13.
Step 2: Gently slide the device cover outwards about 20mm. Two webs connect
the screen to the motherboard. Don’t use too much force.
Step 3: Lift and tilt the cover (gently). Caution: cables are attached to the cover,
screen and motherboard. Do not undo them.
Step 4: Identify the switch mode power supply (SMPS) of the DMP-A6.
Step 5: Disconnect the jumper cable. This is a latched connector. Press the central
part to unlock it, then pull it gently upwards.
Step 6: Use a Phillips screwdriver to remove the 6 screws securing the switching
power supply.
Step 7: Remove the switching power supply module from the DMP-A6 and prepare
the LPS-A6 module.
Step 8: Locate the insulation rings (4 pieces). Place them on the PCB spacers as
shown in the following photos.
Altri manuali BEA Alimentazione elettrica
