Becker AUX-BKR Manuale di istruzioni
Courtesy of: DiscountCarStereo.com
Serving the internet community since 1995
AUX-BKR
QUICK START INSTALALTION GUIDE FOR BECKER RADIOS WITH OPTIONAL CD CHANGER
Not for digital systems (e.g., PCM2+, COMAND)
PRODUCT SAFETY & DISCLAIMER
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE
PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY
•This installation guide is provided as a GENERAL installation guide, some vehicles vary and
may require additional steps. We do not accept responsibility for third party labor charges
or modifications. Exercise due-diligence when installing this product.
•We do not accept any responsibility for vehicle damage or personal injury resulting from
the installation of this product.
•Careless installation and operation can result in equipment damage.
Requirements
Functioning CD changer in trunk or hatch
Introduction
Many European vehicle owners looking for a simply audio jack to play audio
devices on the car Radio while also retaining the CD changer will be pleased to
find the AUX-BKR Adapter.
This AUX-BKR requires and retains optional CD Changer** to provide a
3.5mm dash mount Audio jack which can be used to connect and play all kinds of
audio devices including iPod, iPhones, Smartphones, Mp3 Players on the car
system without sacrificing the changer.
Introduction
Warning: We recommend disconnecting the car battery. But before
anything locate and record the radio safe code. Don’t disconnect battery
if radio code is not available, otherwise radio will cease to operate.
1. Remove radio from dash to gain access to the connectors. A set of
Radio removal tools (See Fig. 1) is required.
Fig. 1
Radio removal Tools
Fig. 2
2. Slide tools into slots (51) on radio. (Straight edge facing away). Withdraw
radio by pulling outwards. To release keys simply press retaining springs.
See Fig. 2. Click here for detailed use of removal tools.
3. Disconnect blue (C-3) green (C-2) plugs and yellow (C-1) plugs from radio
cavity (See Fig. 3)
Fig. 3
Radio connectors
Warning! C-1 chamber (yellow) is present in vehicles with amplifier.
4. Connect Blue plug removed in step 2 to the 8-pin (black) connector on
adapter harness (See Fig. 4).
Fig. 4
connector
5. Mate Blue ISO plug from Adapter harness to green plug removed from
radio in step 2 and this combination should be reconnect to radio (See
Fig. 5)
Fig. 5
mating plugs
6. Carefully route audio jack (See Fig. 6) to a location on the dash or
nearby panel where it will be mounted (within 4 ft.). This location will
vary based on vehicle and customer’s preference.
Fig. 6
Audio Jack
7. Optional: Drill a 9/64”or 5/32”hole in dash or panel, push audio jack
shaft through and secure with nut (See Fig. 7)
Fig. 7
Warning: Jack may be left freestanding, but to be mounted, ensure
panel is less than 4mm thick otherwise shaft may not protrude
enough to engage with nut. If necessary, use dremel, sander etc. to thin
panel or choose alternate mounting location.
Operation
1. Use included 3.5mm audio cable (See Fig. 8) to connect audio device to the
jack
Fig. 8
3.5mm male to male cable
2. Press the CD or unique set of buttons on Radio to enter CD Changer Mode.
Radio display will change to Track or Disc numbers (At least one disc must
remain in CD Changer.)
3. Select a track on audio device. Selected track will play on the car stereo.
Warning! Playlist and Track selection is *NOT* possible from the radio.
You must use the Audio device built-in controls to access music files.
4. Use radio volume knob to adjust playback level
Note: if playback is distorted, lower volume on audio device.
5. To listen to the CD changer, simply disconnect audio device from the
AUX-BKR jack and operate Changer as customary.
Warning! AUX-BKR Audio jack must be empty when listening to the CD
Changer; otherwise, CD Changer playback will be weak or distorted.
6. If correct operation is confirmed go ahead and reinstall Radio
Important Notes:
The AUX-BKR works on any factory installed Becker Radio in BMW, Land Rover,
Mercedes, Porsche, Ferrari etc. and aftermarket Becker Radios (e.g., Grand Prix,
Indianapolis, Cascade pro etc.) that also include an analog CD CHANGERS.
The AUX-BKR WILL NOT WORK with Fiber CD Optic CD Changer applications
(e.g., PCM2+, COMAND etc.)
Plug and play installation to Becker Radio with CD Changer in less than 10
minutes. No wire cutting or splicing.
** External or remote CD changer refers to the optional changer installed on the lower dash,
center armrest, hatch, trunk etc. (external CD changer is not built-into the head unit)
Disclaimer
• This product has no affiliation with Porsche, Becker etc.
• We’re not liable for misuse of this product.
•We recommend professional installation.
© 1995-17 Discount Car Stereo, Inc. All rights reserved. Information in this document is
subject to change without notice. Other products and companies referred to herein are
trademarks or registered trademarks of their respective companies or mark holders.
Indice
