Belling BSO60 Manuale utente

Read this manual carefully before operation

INSTRUCTON MANUAL

COOKER HOOD

Pictures in this manual are for reference only, the product in kind prevail.

BSO60

In certain circumstances electrical appliance may be a danger hazard.

Information and advice

A) There shall be adequate ventilation of the room when

the range hood is used at the same time as appliances

burning gas or other fuels.

B) Do not check the status of the filters while the cooker

hood is operating.

C) Do not touch the light bulb within half an hour after

appliance use.

D) Do not flambé under the cooker hood

E) Avoid opening gas tap

when there is no pan on the

stove, as it is damaging for the filters and a fire hazard.

F) Constantly check food frying to avoid that the overheated

oil may become a fire hazard

G) Disconnect the electrical plug prior to any

maintenance.

H) If the supply cord is damaged, it must be replaced by

the manufacture, its service agent or qualified

technician in order to avoid a hazard.

I) The socket outlet for the range hood must be located so it is

easily accessible for the user after installation. Ensure the

mains supply voltage corresponds with that of the appliance.

J) There is a fire risk if cleaning is not carried out in

accordance with the instruction.

This unit should be installed by a qualified technician, please retain your certificate of

compliance.

This appliance can be used by children aged from 8

years and above and persons with reduced physical,

sensory or mental capabilities or lack of experience and

knowledge if they have been given supervision or

instruction concerning use of the appliance in a safe way

and understand the hazards involved.

Children shall not play with the appliance.

Cleaning and user maintenance shall not be made by

children without supervision.

When the hood is in repair,maintenance,replacement of

parts,please pull out the plug,ensure the safety of the people.

To protect the main body from corrosion from long time

accumulation of dirt,the cooker hood should be cleaned with

hot water with non-corrosive detergent every two months.

The air must not be discharged into a flue that is used for

exhausting fumes from appliances burning gas or other

fuels (not applicable to appliances that only discharge

the air back into the room).

Regulations concerning the discharge of air have to be

fulfilled.

When the range hood and appliances supplied with energy

other than electricity are simultaneously in operation, the

negative pressure in the room must not exceed 4 Pa

(4×10 bar).

Regarding the instructions for the method and frequency of

cleaning, refer to the section “Installation”.

Regarding the instructions for the method of fixing and how

the appliance is to be fixed to its support, refer to

the section “Cleaning Instruction”.

Don't put things on the drawer, so as to avoid dropping in

the operation of the drawer.

-5

Please read these instructions before using your cooker hood.

Congratulations on the purchase of your cooker hood which is designed to include many

superior features that permit you the fullest expression of your living.

Before installing and/or using the cooker hood carefully read all the instruction.

Know your cooker hood

Also include:

User instructions

Check valve

Install screws package

Drawer assembly

Air duct assembly

Main body

4. Filer assembly

U) Regarding the instructions for the blub replacement, thanks

to refer to the section “Replacing Bulb”.

Failure to install the screws or fixing device in accordance

with these instructions may result in electrical hazards.

CAUTION: Accessible parts may become hot when

used with cooking appliance.

Please keep this instruction booklet in a safe place for future reference.

Please read this instruction manual careful: it contains important information

concerning the safe operation, installation and maintenance of the appliance.

The appliance can only be used over a 4 element hob at most.

Ensure the power has been turned off before beginning this installation.

Installation work and electrical wiring must be wiring must be done by qualified

technician in accordance with all applicable codes and standards, including fire rated

construction.

Installation

To install this hood you will require two

assistants. You will need the following

tools and material to complete this

installation: *Drill*Flat head screwdriver

*Phillips head screwdriver or cordless

drill and Phillips head bit*Tin snip*

*measuring tape*hand saw or jig saw*

electrical tap*duct tape

1. Remove the range hood from the carton.

2. Lay the hood upside down on a table

covered with cardboard or paper to prevent

scratching of the table or hood.

We recommend that after installation

the bottom of the hood should be no less than

650mm and no more than 750mm above

the stove’s heating elements and burners.

Plug must be

assembled in places easy to drag and insert .

2. Hang the hood and let it’s 4 key holes aim

at screws, the 4 screws should be in the

narrow parts of key holes. Screws should

be fasten firmly, make sure that the

installation between the hood and cabinet is

scurely fastened.

3. Install screws in the security holes, in case

of front and back moving of hood, so that

the unit is safer.

When cutting or drilling into wall or ceiling, do not damage electrical wiring or other

hidden utilities.

1. According to the figure, make sure the position

of hood in the cabinet. The wood strips should

be line up with the 4 keyholes slots on the top

of the range hood. On the cabinet, install 4

screws(supplied)according to the relative position

of 4 key holes on the bottom of hood.

Method 1

The cooker hood must not be installed and connected to flues where other appliances

are installed and which run off other energy supplied different to electricity(water

heater boiled cookers(range/agas)etc.).

In the installation surface in

cabinet don’t adapt to install

the cooker hood, then as per fig,

fix the position of cooker hood

on the wall. On the wall, install

2 screws(supplied) according to

the relative position of 2 key holes

on the back of hood.

Also install screws in the security

holes, in case of front and back

moving of the hood, so that the

unit is safter

Installation of hoods builtin combi cabinets is thesame as previous method.

Method 2

Activated carbon filter can be used to trap odours

Normally the activated carbon filter

should be changed at three or six months

according to your cooking habit.The

installation procedure of activated carbon

filter is as below.

- Slide the drawer assembly of cooker hood.

- In order to install the activated carbon

filter, the metallicanti-grease filter should be

detached first.press the lock and pull it

downward.

- Put the activated carbon filter into the unit

it in anti- clockwise direction .Repeat the

same

on the other side.Put back the grease filter in

position.

When activated carbon filter attached,the suction

power will be lowered.

Check valve Installation

Hold on check valve with your hands, align

the box gap, put in the check valve , and

then spin to a certain angle until three angles

of the valve are stuck. Installation is complete.

Carbon Filter

Replacing Bulb:

Hood Using Method

Replacing Bulb

1.Switch off the extractor hood and isolate the extrator hood by pulling out the mains

plug or switching off the fuse.

2.Remove the grease filter.

3.Replace the lamp(commercially available filament lamps (max.40watts) or halogen

lamp (max.28watts),E14lampholder).

4.Reconnect the power by inserting the mainsplug or by switching on the fuse.

Operation

Check beforehand

Check the safe condition of the appliance

- Check whether there are visible defects.

- Check that all parts of the appliance have been securely fitted.

Switching on/off

- Slide the front part of the cooker hood.

· There are 3 speeds for the motor and on off switch for the lamp.

- Slide the switch for operation.

· Motor Operation

- [0]=Off

- [1]=Low Power Setting

- [2]=Mid Power Setting

- [3]=High Power Setting

· Light Operation

- [OFF]=Off

- [ON]=On

Disconnect range hood from power supply before cleaning or servicing.

1. Cleaning the surface of hood frequently. Use mild soap or detergent to clean the hood.

2. Do not use harsh alkalis or abrasives

3. Avoid the use of scouring powers or dishwasher compounds.

4. Grease filter may be washed using mild soap or detergent. In normal operation (1 to 2

hours daily), the Grease filter must be cleaned after 2 months. (heavy grease build-up

may not be cleaned easily and the filter may require replacement)

5. Charcoal filter cannot be cleaned.Depending on the frequency of use and the type of

cooking, the expected life of Charcoal filter is from 1 to 6 month. Replacement is required.

When cleaning water must not inter into motor, control switch etc. electrical parts.

Cleaning Instruction

Clean ventilation fans frequently. Grease should not be allowed to accumulate on fan

or filter.

Indice

Altri manuali Belling Cappa di ventilazione

Belling

Belling COOKCENTRE CHIM 90PYR Manuale utente

Belling

Belling BRHCP9BLB Manuale utente

Belling

Belling BC60S Manuale utente

Belling

Belling BL110B Manuale utente

Belling

Belling MK2 Manuale utente

Belling

Belling 60VH Manuale utente

Belling

Belling BPC90BR Manuale utente

Belling

Belling 60ICH SIL Istruzioni di montaggio

Belling

Belling 444410715 Manuale utente

Belling

Belling 60CHIM Manuale utente

Belling

Belling GDACB1100 Manuale utente

Belling

Belling DIH900 Istruzioni di montaggio

Belling

Belling BU90B Manuale utente

Belling

Belling BL90B Manuale utente

Belling

Belling 9000 AWBL Manuale utente

Belling

Belling CHIM101 Istruzioni di montaggio

Belling

Belling BEL CHIM 603PYR Manuale utente

Belling

Belling COOKCENTRE CHIM 90T Manuale utente

Belling

Belling 9000 AWBE Manuale utente

Belling

Belling CRHR6W01 Manuale utente

Belling

Belling 800 STI Manuale utente

Belling

Belling 600-TI Manuale utente

Belling

Belling BRHCF9BLS Manuale utente

Belling

Belling GDACB60S Manuale utente

Manuali Cappa di ventilazione popolari di altre marche

emmeti

emmeti RECUPA MED A-140 Guida

Nibe

Nibe F135 Manuale utente

Kuppersberg

Kuppersberg INTRO 60 Istruzioni di installazione e manutenzione

Zephyr

Zephyr Spruce AK9834BS Guida all'installazione

Hisense

Hisense MH6INBG Manuale utente

Miele

Miele DA 1255 Manuale utente

Broan

Broan 46000 Manuale utente

GE Profile PV977 Istruzioni originali

FALMEC

FALMEC FFRIA24W5FS Manuale utente

Whirlpool

Whirlpool RH2600XL-1 SERIES Manuale utente

Küppersbusch

Küppersbusch DX ISLA Manuale utente

ETNA

ETNA AV360RVS Manuale utente

JUNO

JUNO JDF603E6 Manuale utente

Miele

Miele DA 6708 D Manuale utente

Tricity Bendix

Tricity Bendix LE 150 Manuale

AEG

AEG X68163BV1 Manuale utente

AEG

AEG 125 D Manuale utente

Smeg

Smeg KSEV97X Manuale utente