Product disposal and recycling information
The symbol to the left means that according to local laws and
regulations your product should be disposed of separately
from household waste. When this product reaches its end of
life, take it to a collection point designated by local authorities.
Battery disposal information
This symbol indicates that the product contains batteries that
according to local laws and regulations must be disposed of
separately from household waste. Take used batteries to a
collection point designated by the authorities.
EU Declaration of conformity
Hereby, Bellman & Symfon AB declares that this wireless
device is in compliance with the essential requirements
and other relevant provisions of the R&TTE Directive.
A copy of the EU Declaration of Conformity may be consulted at:
Bellman & Symfon, Södra Långebergsgatan 30, 436 32 Askim,
Sweden.
FCC compliance statement
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Warning: Changes or modications to this unit not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Canadian compliance statement
This device complies with Industry Canada licence-exempt RSS stan-
dard(s). Operation is subject to the following two conditions: (1)this
device may not cause interference, and(2) this device must accept
any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables auxappareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes :(1) l’appareil ne doit pas
produire de brouillage, et(2) l’utilisateur de l’appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre lefonctionnement.
This Class B digital apparatus complies with the Canadian ICES-003.
Bluetooth® certied
This device includes a Bluetooth module which has passed the BQB
certicate. The Bluetooth word mark and logos are owned by the
Bluetooth SIG, Inc., and any use of such marks by Bellman & Symfon
is under licenses.
Important safety instructions
This section contains important information about safety, handling,
disposal, recycling and warranty.
Note: Read all safety information and instructions below
before using the product. Keep the user manual for future use.
Warning!
Failure to follow these safety instructions could result in re,
electric shock, or other injury or damage to the product or other
property.
Do not use or store this product near any heat sources such as
naked ames, radiators, ovens or other devices that produce heat.
Protect the cable from any potential source of damage.
Use only power adapters and accessories specied in this manual.
Only refer a damaged or faulty product to qualied service
personnel.
Do not dismantle the product; there is a risk of electric shock.
Tampering with or dismantling the product will void warranty.
This product is designed for indoor use only.
Do not expose the product to moisture.
Protect the product from shocks during storage and transport.
Care and cleaning
Note: Failure to follow these care and cleaning instructions
could result in damage to the product and void the warranty.
Battery charging and replacement
Warning! The Maxi Pro is powered by a rechargeable lithi-
um-polymer battery. Do not expose the battery to re or
to direct sunlight. The battery should only be changed by Bellman &
Symfon or an authorized service center. There is a risk of explosion if
the battery is not replaced correctly. The battery should be charged
fully before using the product for the rst time. Only charge the
battery in a temperature between 0°– 35°C, 32°– 95° F.
Using the product
Operate the product in a dry environment where the temperature
is always between 0°– 35° C, 32°– 95° F. Do not use or store the
products near a heat source. If the product gets wet or is exposed
to moisture, it should no longer be regarded as reliable and should
therefore be replaced.
Cleaning
Use a soft, lint-free cloth. Avoid getting moisture in openings. Don’t
use window cleaners, household cleaners, aerosol sprays, solvents,
alcohol, ammonia, or abrasives.
Service and Warranty
If the product appears to be damaged or doesn’t function properly,
follow the instructions in this leaet. If the product still doesn’t
function as intended, contact your local dealer for information on
service and warranty.
Warranty Conditions
Bellman & Symfon guarantees this product for two years from date of
purchase against any defects that are due to faulty materials or work-
manship. This guarantee only applies to normal conditions of use,
and does not include damage resulting from accident, neglect, mis-
use, unauthorized dismantling, or contamination howsoever caused.
This guarantee excludes incidental and consequential damage.
Model, type and classication
The information is available at the back of the product.
