C. Connect to power source
-Connection of red wire
Connect red wire of the two-plug to the anode(+) of reversing light
-Connect black wire
Connect black wire of the two-wire plug to car bodywork.
-Fix the connection point with insulating tape.
D. Install the module and buzzer
-Stick the buzzer with the enclosed double-face tape to a place where the
alarming voice can be easily headed by the driver.
-The module must be installed at the dry and free of high temperature place
with double-face tape.
E. Test
-Turn on the auto power, the alarm will begin to work when backing a car and
reversing light flashing.
-Slowly back the car to the obstacle to train the sense of space between the car
and the obstacle, train until you can use it soundly.
F. Settle the easy problems
-The power is turned on, but the obstacle cannot be detected
a. Check against the correction of the anode and cathode of the power
b.Examine whether the power connect to the auto power
c. Judge that whether the power works well
-The display alarms, but nothing founded behind the car
a. Examine whether well connection of power
b.Judge whether there is water, snow or dirt on the sensors
c. When it rains, it is possible to alarm incorrectly
d.Sometimes, on the account of wringing module, it cannot work normally,
when dry, it can work well.
G. Notice in using
-This product is just assistant system, judging the case behind the car
abundantly before braking.
-This product has not be designed to connect with the stop system, please brake
in time once hear the alarm.
-Slowly reverse the car to avoid hitting the obstacle.
-During the first time of using this system, please pay much attention to the
