10
The model variants KS 600-230V, KS 600-400V and KS 700EWK are
ideally recommended for stationary use in your yard, whilst the models
KS 700H and KS 700Z can be conveniently used for firewood produc-
tion straight in the woods.
The models KS 600-230V, KS 600-400V and KS 700E are powered by
electronic braking force control. The electric motor must be connec-
ted to a 16-Amp EC power outlet. In case of alternated power (AC)
230V supplies please make sure to use power cords with a section of
2.5 mm2 [0.0039 in2]. These are normally available on the market as
3x2.5 cables. Power supply is controlled by means of a simple switch/
plug combination.
Make sure the length of the power cord does not exceed 10 m [32 ft].
The model KS 700H is powered from the tractor hydraulics. It supplied
with two hydraulic hoses that must be attached your tractor hydraulics
for saw operation. When attaching and connecting the hydraulic hoses,
remember: to check that they are fit properly both on machine and
tractor side;
Attach he red end of the hose to the pressure side and the blue end to
the return flow side.
If you are operating the saw a stationary machine on a yard, you may
also power it by means of any hydraulic power generator.
The KS 700H variant is additionally equipped with 3 point linkage.
A rugged all steel construction assures longest machine life to all vari-
ants at any operating condition.
Attach models KS 700Z directly to power take off on your tractor using
a PTO driveline.
Press the detent lock inward as you slide the machine shaft onto the
tractor PTO stub shaft. Slide the machine shaft forward far enough to
make sure the detent lock has snapped into the lock position.
Secure the drive shaft with the special restraining chain to avoid
dangerous twisting.
Make sure that the gearbox (Pos 1, Fig. 1) always matches the position
of the catch on the tractor and faces the direction of driveline revolu-
tion.
Once you successfully connected the saw to a tractor’s 3 point
hitch, and installed the PTO driveline, you are ready to start using it.
Strictly engage the PTO driveline, with the machine/tractor idled. First
off, locate and engage the On/Off saw switch on the left hand side of
the saw.
Then increase the speed of tractor PTO stub up to max. 420 RPM. Now,
the saw is ready for use.
To stop the saw when finished, repeat the same operation in the re-
verse order: slow tractor speed down, switch the saw off, disengage
the PTO, stop the tractor engine, and finally remove the gearbox.
Make sure to disconnect power (switch the tractor off) before perfor-
ming any work (maintenance or repairs) on the saw.
5. OPERATION
Fig.1
