flashes once mean host will remind once, and flash
twice means remind twice, and so on.
4.4 Installing your Sensor
We recommend mounting the motion sensor at least 3
to 4 ft (1 m) above the ground and (6-8m) away from the
driveway on a sturdy, non-metal surface (i.e. a wall,
wooden post or tree). This will decrease or eliminate
false alarms from small animals, give you a longer area
to pick up movement, and avoid unwanted alarms from
nearby lawns/roads.
Please Note: Alway s test that your se nsor is
working in your desired location before installing
it. Avoid placing your sensor in a location where
sunlight will shine directly into the sensor eye.
Direct sunlight may cause false alarms and/or
damage to the PIR sensor.
If the host "BEEP" and flash once, indicating that this
sensor has been bound into other zones;
If the host "BEEP" and flash three times, indicating that
defense zone 1 is full.
Long press【 】, the host will "BEEP" and flash four
times, indicating that you have deleted the sensor of
this zone.
Please Note: Learn mode has a time-out feature
after 20 seconds of inactivity. If you didn’t hear a
beep confirming that your sensor was paired,
repeat the pairing process and make sure that your
selected zone is still flashing when you activate the
sensor.
C . Set up the Alarm Music
When under learning status of the defense zone,
press【 】to set up the music of this zone, each
defense zone can ONLY set up one type of music, no
matter how much sensors have bound.
When under learning status of the defense zone,
press【 】to set up the reminder time, alarm music
can set up to remind from once to four times. The LED
1 foot away
98
