INTELLIPRESS™ELECTRIC BENCH TOP PRESS
User Manual
BIM-IEBTPM-1218 Rev 1 | For Technical Assistance: 800-442-4622
10
Press on the parameters to be modified to bring up a pop-up keypad (Figure 8).
See Figure 8: Pop-Up Keyboard
The following parameters can be modified from the Setup - Manual Operations Screen:
• Jog+ / Jog-: Indexes the press ram UP (+) or DOWN (-).
• Initial Position: The location below the Home Position to where the press will return after each
automatic cycle.
• Initial Position Speed: The speed at which the press travels from the Home Position to the Initial
Position and from the Approach Position to the Initial Position.
• Approach Position: The location below the Initial Position where pressing torque begins.
• Approach Position Speed: The speed at which the press travels from the Initial Position to the
Approach Position. This also includes the speed at which the ram will retract to the Home Position.
• Full Down Press Position: The final ram position.
• Full Down Press Position Speed: The speed at which the press applies force in the downward
direction.
• Full Down Press Position Force: Expressed as a percentage of the force rating of the press, this is the
pressing force applied to the part.
• Home Position Button: Directs the press ram to the Home Position.
• Initial Position Button: Directs the press ram to the Initial Position.
• Approach Position Button: Directs the press ram to the Approach position.
Taskbar Definitions:
• Error Reset: Resets any alarms or faults in the press controller.
• Home Icon: Returns to the Logged-In Screen (See Figure 5 on page 9).
• Stop Icon: Stops the program operation of the press. Note: The stop icon does NOT remove power
from the motion control system
Modify the Setup - Manual Operations values as necessary.
When manual operations are complete, press the Home icon.
