
Installing and removing of band
1. Open the front door. The toggle switch can change the mode between "inserting
band mode" and "banding mode". If the switch is in the upper position, it is
"inserting band mode" and the lamp of the Power/Re-set button will start blinking.
Open the band door and put band in the band holder. Make sure band will unroll in
the right direction(counterclockwise).
3. If too much of the band is rolled in or jammed around the rollers, press the
Start/Backward button and then the roller will turn the other way around to allow removal
of the band.
4. Push down the toggle switch. It will convert to banding mode and the heater be heated.
If the current temperature is far below the set value, the Start/Backward button will be lit
up. If it is a little below the set value, the Auto/Forward button will be lit up. If the
Power/Re-set button blinks, it indicates that the current temperature has reached the set
value, when pushing the Power/Re-set button will cause any leftover band will be cut off,
and new band will be put in place.
5. Adjust the band feeding control to change the length of the band fed on the unit by
turning the volume in your direction or the opposite direction to increase or decrease the
length, respectively.
6. When failed to insert the band into the machine or re-insert the band for re-
arrangement, press Power/Re-set button and hold 2seconds for the band to be cut off and
machine will re-band.
2. Close the band door and hold the end of the band,
push it through the guide roller and assistance guide
and then between the Idle roller and the main
roller. Press the Auto/Forward button, then the rollers
will turn to move the band forward. At this point,
allow the band to roll in automatically as shown in
the diagram.