1. Power Switch
Turn the power ON or OFF.
2. Feed Button
The band is fed to the rail when the red button is pressed.
The RED LED lights up when the band is normally set.
Otherwise, the RED LED blinks.
3. Auto Button
The ORANGE LED lights up, and the auto mode is enabled when the button
is pressed. The ORANGE LED turns off, and manual mode is enabled when it is
pressed again. The machine works in auto banding when the sensor detects
any object in auto mode.
4. Start Button
The GREEN LED lights up, and manual mode is enabled when the power is
turned ON.
5. Object Sensor
It detects an object that is put on the machine for banding, and then the
GREEN LED blinks.
6. Temperature Control Knob
This control knob is used to adjust the heater temperature
for banding.
The heater temperature rises when the control knob
is turned clockwise.
7. Tension Control Knob
This control knob is used to adjust
banding tension, which increases
when the control knob is turned clockwise.
8. Band Set Lever
This lever is used to set the band. Raise the lever, insert the band, and press
the feed button to transfer it to the rail.
9. Rail Opening/Closing Lever
Press or release this lever to open or close the rail respectively.
Open the rail you can remove the band when jammed.
