Step 4: Detection
•After the Bluetooth connection is completed, go to the test item selection menu and select
the product category you want to detect.
•After selecting the product category, enter the test item menu. Please select the
corresponding test item according to the type of rapid test strip you are using.
•The instrument starts reading automatically, then test curve and the test result are displayed.
Others
•Click the “Input Data” button below the detection result to save the data or upload later in
the “Record” interface.
•If you need to save the test result with test strip or milk sample information, please fill in the
relevant information of the sample’s name firstly, or click “+” to add the photo of the test strip
according to your requirements. Then the screen will display “Enter Successfully”, record data
of the test strip is completed.
•If you don't need to upload, click the “Back” button at the top left of the screen. The test result
can also be inquired in the “Record” interface.
Fault phenomenon Cause of issue Treatment
LED light is not lit,
Bluetooth list
cannot find device
1. Change battery
2. Contact customer service to return
to the factory for repair
Unable to read test
strip data
1. Is the test strip installed correctly?
2. Is the insertion direction and position
of the test strip slot correct?
1. Check and adjust the installation
position of the test strip
2. Check and adjust the insertion direction
and position of the test strip slot.
Generon S.p.A.
Via San Geminiano, 4
41030 San Prospero (MO)- Italia
:
+39
059
8637161
: +39 059 7353024
:
ie.techsupport@generon.it
www.generon.it
Common troubleshooting
1. Low battery or exhausted power
2. LED light failure
3. Hardware failure
