AutoFill V2
T0031 (0) 348 563 839 Wwww.bithotmelt.com 9
Let the control unit of the Automatic Granulate Feeder turned off.
Step 1: Check if the glue is completely melted. The sensor responses different
to solid or liquid glue.
Step 2: Place the sensor in the hole in the synthetic base.
Step 3: Make sure that 2 - 4 cm from the sensor is above the synthetic base.
(depends on type of tank and desired adhesive level).
Attach the washer to the sensor
Step 4: The adhesive level must be the same as ‘adhesive level 1’ as shown
in figure 4, so that the sensor is at least 40mm in the adhesive.
Step 5: Wait at least 5 minutes for the sensor to reach the adhesive temperature.
The range in the sensor is +/- 5mm from the bottom of the sensor, till +/-
20mm from the bottom of the sensor.
Continue with chapter 5.2 to calibrate the levelsensor.
5.2 Calibrate the levelsensor
Step 1: Switch dipswitch 1 to ON. The system is in ‘calibrate mode’.
Step 2: Close the control box and supply it with power.
Step 3: The led ‘hand’ flashes. Press button ‘hand’.
High level is now saved.
The led ‘auto’ starts to flash.
Step 4: Check the adhesive level in the tank, by removing the filltower.
Make sure that the AutoFill is voltage free.
Bij het openen van de aftapkraan kan de lijm ongecontroleerd uit de opening komen.
