BJ-889 BJOY Ring Wireless
Page 6
BJ-889 BJOY Ring Wireless
2.3 Assembly of the Receiver
The receiver is an USB device that must be plugged to the USB port
of a computer or to a compatible mobile device using an USB-OTG
cable.
Follow these recommendations to ensure the correct operation
of the device:
oUse the provided extension cable with cradle to place the receiver
in a visible place. Avoid to plug it at the back of the computer.
oPlace the receiver far away from interferences from other devices.
oDo not place it close to metal areas to avoid the screening effect.
oProtect the receiver from liquids and avoid water entering
Each device is provided with one receiver paired to the emitter.
One emitter can be paired up to four receivers. If the user wants
to access more than one device or devices in different places, it is
possible to order more receivers.
IMPORTANT: To learn about the use of the BJOY Ring wireless with
compatible smartphones and tablets see section “Use with compatible
smartphones and tablets” in the user guide.
2_ Getting started
Charge up the emitter’s
battery using the micro USB
cable connected to the USB
port or to the mains with the
USB type power supply.
While the battery is charging
the battery LED (red) flashes.
When the battery is fully
charged the battery LED stops
flashing.
The LED turns off when the
cable is disconnected.
