Good Vibes & Nice Bikes
1.3. Vehicle operation
Prepare your Bonfire
1. Make sure that both batteries are equally fully charged. It is best to switch off both
batteries so that no sparks occur when plugging them in.
2. First place a battery and connect it to the motorcycle.
3. Now also place the second battery and connect it to the motorcycle.
4. Move the battery lock down & turn on both batteries.
5. To close the battery box, you need to push the door slightly against the seal, then
you can close the lock by turning it to the left.
6. Make sure that the steering wheel lock and all other locks are unlocked.
Start your Bonfire
1. Press the Unlock button once to disable the alarm system (C)
2. Press the Bolt Button twice (D)
3. Now the display and the lights should be on.
7. Fold up the side stand and sit on your bike.
8. Make sure the kill switch is turned on and press the starter.
9. If your riding mode is shown on the display, the bike is now active and you can start
riding. If you still cannot start your bike, you may need to raise the side stand.
10. To prevent injuries, there is an additional safety feature. When you stop after riding,
"Active" is shown on the display to remind you that the bike is still on.
Finish your ride
1. Unfold the side stand and make sure the Bonfire is stable.
2. To turn off your motorcycle, press the unlock button (C) once. Now the lights and
the display should go off.
3. If you leave the batteries in the vehicle, you can switch on the alarm system. Press
the lock button (A) once.
4. We generally recommend that you always remove the batteries to protect them
from theft. In this case, you do not need to turn on the alarm, but you can remove
the batteries by pressing lightly against the side door of the battery box and turning
the lock to the right.
5. Now slide the battery lock up, disconnect the batteries from the vehicle and pull
them out carefully
6. Lock your Bonfire, see chapter 1.6.3
