PENTLAND WHOLESALE LTD. www.pentlandwholesale.co.uk +44 01254 614444
1. Warnings for installation
1.1 Installing the oven, in a location free from rain and snow, and near the fire extinguisher.
.2 A wet oven can be a source of electrical shock and the oven can be damaged.
.3 Be sure to install complying with industry standards. Incomplete installation can cause stumbling
accidents, electrical shock, fire or water leakage.
.4 The rubber feet must be installed on the equipment firmly. Do not use the oven without feet.
.5 Do not install any equipment on the floor.
1.6 Do not carry the oven by yourself. Ask for another’s help. The oven should not be carried by one
person; otherwise it may be dropped and cause injury.
.7 Be sure to install the oven on a flat and solid surface. Otherwise the unit may topple over, causing
injury or burns, or water in the unit may overflow. If someone suffers burns, cool the affected part
with cold water and have them see a doctor immediately.
.8 Be sure to provide with clearance of at least 4 inches (10cm) between the unit and walls. Insufficient
clearance may cause generated heat to damage the other ambient products.
.9 Remove all the adhesive film which cover the body surface before using.
.10 Be sure to connect the power cord complying with industry standards.
.11 Check the power supply to see if it can satisfy the specification of the oven. The working voltage
range can not out of ±10% when the oven working. Violating this standard can cause electrical
shock or fire. If you cannot identify the specification of the power supply used, consult the supplier.
.12 Be sure to connect a ground wire to the oven. Operating the oven without grounding it can cause
electrical shock or fire by a short circuit.
.13 A bi-pole switch must be installed between the oven and the power.
1.14 Do not bundle the power cord; otherwise a fire can be cause.
.15 Do not step on, squeeze, or forcedly twist the power cord; otherwise the power cord can be
damaged, causing electrical shock or fire. If your power cord has been damaged,consult the supplier
for replacement.
2. Warnings for operation
2.1 Do not operate any switch with a wet hand; otherwise, you can get an electrical shock.
2.2 Do not use combustibles (e.g., thinner), combustible gases, or volatile matter near the oven;
otherwise explosion or fire can be caused.
2.3 Do no put anything on the oven while using oven. The heat could cause deformation, cracking, etc.
2.4 Be careful not to burn yourself during use or immediately after use.
2.5 The metal parts and glass window of the door become extremely hot during use; be careful not to
touch them when opening and closing the door.
2.6 Do not immerse the heater. If a drop of water gets into the heating element from the connecting part,
