Warning
1. Do not use the battery pack for other purposes other than those specified. Otherwise, its
guaranteed performance will be lost and/or its service life will be shortened.
2. If recharging operation fails to complete even when a specified recharging time has
elapsed, immediately stop further recharging.
3. Do not subject to excessive micro-wave radiation.
4. Do not subject to excessive ambient pressures.
5. If the battery pack gives off an odour, generates heat, becomes discoloured or deformed,
or in any way appears abnormal during use, recharging or storage, immediately remove it
from the equipment or battery pack charger and stop usage immediately.
Caution
1. Do not use or subject the battery pack to intense sunlight or hot temperatures such as in a
car in hot weather.
2. Do not use it in a place where high static electricity may be present.
3. The guaranteed operating temperature range is 0°C to 40°C.
4. If electrolyte leaking from the battery pack contacts your skin or clothing, immediately
wash it away with running water. Failure to do this may result in skin inflammation.
5. Keep out of reach of children.
6. If you find discolouration, a bad odour due to leakage, overheating and/or other
irregularities when using the battery pack for the first time return it to your supplier or
vendor.
7. Do not store battery packs on chargers or idle equipment.
8. The battery should be stored in a dry place at normal temperatures, ideally below 20oC
and not above 60oC (recommended 0oC to 20oC). The battery is a perishable item, more
attention and care need to be used:
It is recommended to charge the battery after each use.
If the battery is not going to be used for a prolonged period of time, it is advisable to
recharge the battery so as not to store it in a very low state of charge. Remember
that there will always be some internal power consumption.
It is advisable to check the state of charge every 6 months and if possible to exercise
the battery regularly.
1. Set-up and Operation
1. For battery packs with a USB type-A connector, the output may need to be activated by
pressing the charge indicator button.
