4.2.2 Set ID for PT80
Command : <password>GID<ID>
Example: send this SMS 000000GID115123456 to tracker
PT80 will reply with an SMS (SET OK, ID= 115123456) to confirm this setting.
000000 is default password.
Please make sure you set the same tracker ID with the one you added to the LiveGTS as above step
4.2.3 Set APN
Command: <password >APN<APN>, <User>, <Pass>
Note: If your APN doesn’t have username and password, please inputAPN only.
SMS Example: 000000APNCMNET (CMNET is China mobile’s APN, no username & password)
PT80 will reply with an SMS (SET OK,APN: CMNET, USER: PASS :) to confirm this setting.
You can ask your GSM operator for your simcardAPN, username and password
4.2.4 Set server and port
Command: <password> SVR<IP/domain>, <Port>
SMS Example: 000000SVRDEMO.LIVEGTS.COM, 8080
PT80 will reply SMS (SET OK, IP: DEMO.LIVEGTS.COM) to confirm this setting
We strongly suggest you setting domain as IP, because domain name is more easier to be remembered than IP
4.2.5 Set Report Time Interval for Sending GPRS Packet
Command:<password>GTI<Report time interval>
SMS Example: 000000GTI30
PT80 will reply SMS(SET OK, GTI:30)
Then PT80 will report data by GPRS to server every 30 seconds. We suggest time interval >= 30 seconds. Time interval
value should not exceed 65535 seconds.
You will be able to see your trackers on the map in the “Real-time” page of the LiveGTS software if all above settings
correct.
After PT80 connects to software successfully, you can:
--Get street address by SMS request
The tracker must work on the LiveGTS successfully and get good GPS&GPRS signal.
- 8 -