Bosch OCL8850 Manuale utente
OCL8850 Quick Reference Guide
Check wheel bearing.
Note: Rotor must remain in
place on hub at all times.
Remove wheel.
Fix all bolts/nuts and drive
adapter 50 Nm (37 ft-lb).
Remove caliper and clean
mounting surfaces.
Fit rubber silencer. Fit adapter; bolts M10 or larger
[50 Nm (37 ft-lb)].
Fit lathe [50 Nm (37 ft-lb)],
place drive unit, and machine rotor.
Read and follow the instruction manual before assembling, installing, operating, or servicing the equipment. 577365 REV A
OCL 8850
Aligned Lathe
Left Switch Panel
(right panel is mirrored)
Drive Unit
insert
36 VDC inlet
switch panel
cutting depth adjuster
1 click is 0.002 inch (0.05 mm)
flashes red
when active
flashes red
when active
switch panel to
operate slides
power
indicator light
auto feed
6 mm/min
0.24 inch/min
auto feed
12 mm/min
0.47 inch/min
push once to start
push once to stop
direction
indicator arrow
speed adjustment
80–160 rpm
direction/start
switch
emergency
stop
handle bar height
adjustment
slow out fast outfast in
hold button to operate
slow in
direction indicator
arrow
Indice
Altri manuali Bosch Tornio
