Please follow these guide lines to get the
best out of your watch.
Movement
If the watch is worn daily for about 12 h, the
movement is automatically winded by its
rotor and no manual winding is needed.
However if the watch has stopped since not
used for a period of time manual winding is
recommended to start it. This is done with
the crown in position 1. The crown should be
turned clockwise, approximately 15-20
turns.
To fully wind the movement 65 turns are
required. Daily manual winding is not
recommended since the movement is not
designed for this.
The accuracy stated in the specifications
section may change over time. As a
mechanical watch, quartz watch accuracy
cannot be expected.
Magnetic fields
Avoid placing your watch on electronic units
which can generate strong magnetic fields,
e.g. loudspeakers, since this can affect the
watch performance.
Shocks
It is recommended to avoid exposing your
watch to mechanical and thermal shocks, as
it may damage your watch and delicate
movement parts.
Service
Your watch consists of hundreds of small
parts and needs service regulary to maintain
its performance and accuracy. Full service is
advisable every 4-5 years. It is
recommended to be performed by an
approved watch maker or sent to Bravur
service center. Contact us for more
information.
Cleaning
To clean your watch, use a tooth brush and
some water and mild detergent. Do not rinse
the watch under water and avoid the leather
strap to come in contact with water.
Water resistance
Your watch is tested to resist 5 ATM of static
pressure. Please note that this is not equal to
resistance in water. Your watch will withstand
everyday use like light rain or high humidity,
but please leave your watch on the poolside
when going for a swim, and leave it outside
the shower or sauna.
Gaskets and seals should be inspected and
replaced by a watch maker to maintain full
water resistance.
Leather straps
Avoid leather and nubuck straps to come in
contact with water, as it will shorten its
life-span.
04.
Care &
maintenance
