10
6. As unit operates, condensed water will
drain into water reservoir. When water
reservoir is full, unit will beep 10 times and
WATER FULL indicator light will blink.
Unit will automatically stop operating.
The water reservoir must be removed and
emptied before unit will operate again.
POWER DOWN PROCEDURE
Important: As a protection mechanism the
fan will continue to run for 4 minutes after the
internal heater switches off.
To switch off the unit press the POWER button.
The heater will immediately switch off and
the LED lights on the display panel will switch
off. The fan and motor will run for a further 4
minutes before switching off automatically.
ENERGY SAVING FUNCTION
When the set humidity ratio is reached the
unit will automatically power down. The unit
will then test the environment humidity by
running on low speed for 3 minutes in every
30 minutes. If the humidity raises above the set
humidity then the unit will automatically start.
PROTECTION OF INTERNAL OVER
HEATING
In the event the unit malfunctions and
overheats due to air intake or air outlet being
obstructed or blocked by foreign objects, the
unit will shut down automatically. Unplug unit
from wall socket and allow unit to cool down
for a minimum of 5 minutes before operating
the unit again.
NOTE
The appliance air vents and air grilles must not
be obstructed at any time. Air flow is required
for the unit to operate effectively. Place unit
in a flat well-ventilated location at least 30cm
from wall or other appliances. Units must
be placed on a flat stable surface to reduce
possible excessive vibration and noise.
TILT PROTECTION
In the event that the unit is knocked over or
tilted over 45o angle while in operation, the
internal heater will stop operating. The fan
and motor will continue to run for 4 minutes
(to cool down the unit) before stopping
completely.
Once the machine is fully upright, the unit
will need to be turned on by pressing POWER
button. The unit will start operating as per its
last settings, except for the timer which will
need to be re-set.