Bronpi Sena Manuale utente

Modelo SENA

INSTRUCTION MANUAL

Dear customer:

E G We would like to thank you for choosing one of our products. The product

you have just purchased is highly valuable and this is why we kindly invite you

to read carefully this brief manual so as you can make the most of your

equipment.

GE ERAL WAR I GS

E G The installation of the stove must be done according to the local regulations,

including those referred to the national or European rules.

Our responsibility is limited to the supply of the equipment. The installation

must be done according to the foreseen procedures for this type of

equipments, following the prescriptions detailed in these instructions, and the

rules established for this profession.

The responsibility of the ensemble of the

installation will fall on the installation engineers or, if it proceeds, on the

company in charge of the installation; however, in both

cases they must be

qualified and renowned personnel.

IMPORTA T! This product includes a spray tin inside the combustion chamber

or oven (where applicable) that needs to be removed before starting up the

equipment.



REGULATIO S

E G To get a perfect combustion regulation, this model presents different

regulation. The working process is as follow:

PRIMARY AIR REGULATIO

ARRANGEMENT AND ELEMENTS REPLACEMENT /

E G We will find a rectangular piece inside the combustion chamber, which is the

deflector. The absence of a deflector causes a big depression with a very fast

combustion, excessive wood consumption, and the subsequent overheating

of the equipment. It normally comes installed from the factory and to remove

it we need to proceed as follow:

2.1 DEFLECTOR

2.2 I TER AL SHEETS.

E G The internal part of the combustion chamber consists of vermin

culite sheets and we should never use the equipment if these sheets have

been removed.

In case of breaking the sheets, in order to replace it we need to remove the

deflector and proceed as follow:

Start by removing one of the sides; to do so we need to raise the sheet a little

bit and then bend it so as to get it out.

E G

- A “cold hands” handle to open the door. To install it we need to

introduce it from top to bottom and then spin it around.

TECH ICAL FEATURES /

EXPLODED VIEW DRAWI G /

Potencia calorífica / Puissance nominale/ Nominal output

9 kW

Rendimiento / Rendement / Efficiency / Rendimento 75 %

Emisiones CO (13% O2) / Taux de CO (13%O2) / Emissions of

CO (13%CO) / Emissões CO (13% O2) 0.29 %

Temperatura de humos / T° fumées / Flue gas temperature /

Temperatura de fumos 333 ºC

Conducto de humos / Conduit de fumee / Diameter of pipe /

Conduta de fumos Ø 150 mm

Carga combustible/ Combustible recomendé / Fuel consumption /

Carga combustível 2.7 Kg/h

Longitud maxima de leña / Longueur maximale de buches 55 cm

Peso / Masse de l’appareil / Weigth / Peso 70 Kg

N°

DESCRIÇÃO / DESCRIPTION

N°

DESCRIÇÃO / DESCRIPTION

1 Base 15

Rejilla

2

Salida Humos

16

Maneta Perno

3

Puerta

17

Maneta Tirador

4

Solapa C

ajon

18

Pata

5

Cajon

19

Deflector

6 Regulacion Primaria 20

Vermiculita Trasera

7 Pomo Regulador 21

Vermiculita Lateral

8

Soporte Bisagra

22

Techo

9

Pernio Bisagra

23

Sujeta Vermiculita Lateral

10

Limpia Cristal

24

Sujeta Vermiculita Trasero

11

Cris

tal Puerta

27

Salvatroncos

12 Trasera Techo 28

Doble Combustión

13 Frontal 29

Regulación Secundaria

14

Plano Fuego

IMPORTANT

E G This product can be installed next to the walls of the room, provided that they

meet the following requirements:

•To respect a distance of about 5-10 cm. to the wall.

•To check that the wall is completely made of brick, fireproof brick

blocks, concrete, thin hollow brick, etc., and that they are covered by

a material susceptible to support high temperatures.

Therefore, in the event of the wall being made of any other material

(plasterboard, wood, non glass-ceramic, etc.) the installation engineer should

foresee an adequate isolation or leave a minimum security distance to the wall

of 80-100cm. In this case, it is compulsory to use thermal insulated pipe.

The data provided in this manual are not binding.

The company reserves the right to carry out modifications and

improvements without notice.

Indice

Altri manuali Bronpi Stufa

Manuali Stufa popolari di altre marche

Arada

Arada Cassette Stove Manuale utente

Parmco

Parmco FS 600 Manuale utente

MCZ

MCZ SUITE AIR 10 M2 Manuale utente

HearthStone

HearthStone Stowe DV 8321 Guida alla risoluzione dei problemi

Cattara

Cattara FAMILY Manuale utente

Stanley

Stanley Argon F500 OVAL Manuale utente

Avalon

Avalon B-VENT Manuale utente

Nordpeis

Nordpeis Vega Manuale utente

Exquisit

Exquisit EKC601-5 Manuale operativo

Stanley

Stanley Oisin Oil MK II Manuale del proprietario

Thermocet

Thermocet Brookfield S/CC Manuale utente

HASE

HASE delhi Manuale utente

Vermont Castings

Vermont Castings Intrepid 2 Manuale utente

Italiana Camini

Italiana Camini CLASSICA Guida rapida

Avalon

Avalon Vashon Avanti DVS FS Manuale utente

Spartherm

Spartherm ambiente a1 Manuale utente

Dimplex

Dimplex MCFSTV12AU Manuale utente

Warmlite

Warmlite WL46040 Manuale utente