Bryan Steam LLC, 783 N Chili Ave, Peru, IN 46970 Web: www.bryanboilers.com
10
A. Receiving the Boiler
feet/legs bolted to the skids. These are provided to
with spreader bars to prevent damage to the boiler.
B. Boiler Water and Condensate Connecons
Do not run any pipes along the tube access panel side
of the boiler. Maintain clearances as shown on the
dimensional drawing for servicing of the boiler tubes.
See Figure Figure 4 and Table 2) All piping should be
designed and installed to avoid any loadings on the
1.
a.
are shown on Figure 1. A gate valve should be
installed on the boiler outlet and inlet lines.
This allows the boiler to be isolated from the
2. Safety Relief Valve
a.
relief valve discharge piping must be the
same size as the safety relief valve discharge
opening and run to a point of safe discharge.
the relief valve and the appliance or in the
this can distort valve seats. All piping from the
supported with no weight carried by the
valve.
NOTICE
due to thermal expansion in a closed water supply
system. Contact the water supplier or local plumbing
b.
systems shall be 30 psig. The system shall
c. For systems designed to operate at delta T’s
The system shall operate with no less than
water hammer.
3.
a.
be provided by others in the system piping
separate from the boiler.
4.
a. A drain valve must be installed on the boiler
5.
a. A condensate drain trap is shipped with
the boiler and is provided with a 1” npt
the pH of the condensate should never have
a value lower than 3.5. NO VALVE is to be
installed in this line from the boiler to point
of discharge.
b.
with water as part of your boiler maintenance
schedule to remove any debris that might
