Cal-Royal NM Series Manuale utente
HOW TO CHANGE HANDING
If it is necessary to change handing, the instruction is as follows.
1. Use Hex Key to unfasten the screw in the hole behind latch bolt (green label).
2. Pull latchbolt out until it is entirely away from lock case.
3. Rotate latchbolt to adjust handing.(see page 3)
4. Fasten the screw tightly into the hole and glue with Threadlocker (Loctite 242).
5. Use screwdriver flat head that fit on locking piece (green label) Push to Front
Side.(See illustration on page 2)
6. Handing is completely reversed.
Hex key
hole(green label)
latchbolt
locking piece
(green label)
Warning!
Please read the instruction on
the installation guide about the
correct position of spring cage.
1 2
OUTSIDE/KEY SIDE
INSIDE
HOW TO REVESE LOCKING PIECE FROM FLUSHED SIDE TO HOLLOW SIDE: Use a tool, preferably a flathead screw driver that
will fit into the locking piece slot (FIGURE 1). Push the locking piece down (FIGURE 2).
1 2
3 4
HOW TO REVERSE LATCH
Indice
Altri manuali Cal-Royal Serratura
Cal-Royal
Cal-Royal CRCODE-202 Manuale del proprietario
Cal-Royal
Cal-Royal CR9000 Specifiche tecniche
Cal-Royal
Cal-Royal CR3000 Manuale utente
Cal-Royal
Cal-Royal ES1520 Series Manuale utente
Cal-Royal
Cal-Royal CR9000 Specifiche tecniche
Cal-Royal
Cal-Royal CR3000 Guida rapida
Cal-Royal
Cal-Royal SDLP-SQ-ADA Manuale utente
Cal-Royal
Cal-Royal ALC Series Manuale di istruzioni
Cal-Royal
Cal-Royal SDLP-RND-ADA Manuale utente
Cal-Royal
Cal-Royal ES1934 Series Manuale utente
