CBT Supply EZ Cinch Manuale di istruzioni
Installing
Mounting Bracket
EZ Cinch Body with
Ratchet and Straps
Ratchet Wrench
(Ships stowed in EZ Cinch body)
Locking Pin
(You may substitute your own padlock or cable tie).
EZ Cinch is an adjustable CPU holder
system that works with a wide range
of CPU sizes, from small form factor
to full sized tower.
The hardware provided lets you
install under any table to keep your
CPU conveniently located off of the
floor and under your work surface.
Parts
©2007 CBT Supply, Inc. All Rights Reserved. Please call 800-770-7042 if you need technical support. 1
Using wood screws provided,
install the mounting bracket on the
underside of the table.
The mounting bracket has 4
studs into which the EZ Cinch body
will slide and lock. The bracket
positions the EZ Cinch at an ideal
height for easy access to drives
and cable connections.
Install Mounting Bracket
The Mounting Bracket is designed to work with
the HorizonLine™ Leg System, used on Horizon-
Line™ and Pi™ computer tables. Use the Phillips/
Hex Head bolts supplied with the table (pictured
above) to install with the leg mounting bracket
as shown.
Wrap Straps Around the CPU
Adjust the position of the metal clips
with extra slack to go around your CPU.
Small form factor, large towers and con-
toured cabinet shapes are no problem.
Insert the metal clip into the EZ Cinch
body, then pull on the straps until both
are evenly snug.
Locate the Ratchet Wrench, stowed
in the body of the EZ Cinch.
Use the wrench to tighten the straps
to hold the CPU securely.
If you need to release the ratchet
to reposition the straps, use the
release lever.
©2007 CBT Supply, Inc. All Rights Reserved. Please call 800-770-7042 if you need technical support. 2
Tuck In the Straps
The straps are longer than you
will need, so gather up the
excess and tuck it into place as
shown for a neat installation.
Hang EZ Cinch on
Mounting Bracket
Capture the mounting studs
in the slots on the top of the
EZ Cinch body. Slide into
position, placing the locking
tab through the slot on the
back of the mounting bracket.
Interlock EZ Cinch Body to
Mounting Bracket
The hairpin clip is provided to interlock the
mounting bracket to the EZ Cinch body. You may
choose to use a cable tie or your own padlock to
make the interlock harder to take apart. The wire
clip provided is easy to remove for access, and
keeps EZ Cinch in place during use.
©2007 CBT Supply, Inc. All Rights Reserved. Please call 800-770-7042 if you need technical support. 3
Small form factor CPUs, full sized towers,
even contoured CPU cases are no
problem for EZ Cinch. Straps easily
adjust and conform to any size case.
Keep you CPUs off the floor, protected
from building maintenance hazards.
Have full IT access to drives
and connections.
©2007 CBT Supply, Inc.
All rights reserved.
For technical support,
please contact technical
services at
800-770-7042.
©2007 CBT Supply, Inc. All Rights Reserved. Please call 800-770-7042 if you need technical support. 4
Altri manuali CBT Supply Accessori per computer
