7
To replace the battery, grip the tool as illustrated in the Figures 1a and 1b.
B1500A: grip the tool as illustrated in Fig 1a, press the release button (10) and push the battery
downward unlocking it.
B1500NA: position the tool as illustrated in Fig 1b, press the release button (10) and pull the bat-
tery unlocking it.
Insert a charged battery from the bottom by sliding it into the guides until it locks.
Thedisplayshowsthe operationalparametersofthetool;tocustomisethemproceedasdescribed
in § 2.7.
Select the appropriate die set for the connector to be crimped and insert them into the tool head
as described in § 3.
When introducing or changing dies, the battery must rst be removed from the tool.
Insert the conductor into the connector and position the
connector between the die; if necessary open the tool
head by means the locking pin (4) (Ref. to Fig. 2).
Ensure the correct location of the crimp.
NOTE:whenmorecompressionis
required,proceedaccordingtothe
sequence and direction indicated
inthegure,uniformlyspacingthe
compressions.
Beforecarrying out further
crimping operations make
sure the locking pin (4) is
completely inserted: its partial
insertion may damage the tool
head.
2.2) Die advancement
Pressoperatingbutton(1)toactivatethe motor-pumpand advance
the lower die.
To halt the advancement, release operating button and the motor
will cut out.
Make sure the dies are exactly positioned on the desired crimp
pointotherwisere-opendies followinginstructionsasper§2.4
and reposition the connector.
2.3) Compression
By keeping operating button (1) pressed, the motor continues to operate: the ram will gradually
move forward until the two dies touch.
The motor will stop automatically when the set pressure has been reached.
Toperformpropercompression,pressandholdthe operatingbutton(1) untilthemotor stops
automatically.
12
12
21
terminal
connector
conductor
conductor
1
