CHAMELEON Retractable Hose System Istruzioni operative

512 West Gorgas Street §Louisville, OH 44641-3912

www.chameleonvac.com

Dealer Name

Dealer Phone

80205 • 5/19

Finishing & Operating Instructions

Attention Installer: Please be sure this manual and warranty

information are left with the customer when installation is complete.

TABLE OF CONTENTS:

General Information ....................................................................................... 3

Completing the Installation............................................................................ 3

Installing the Hose into the Valve .................................................................. 4

Shortening the Hose ...................................................................................... 5

Using the System ........................................................................................... 6

Storing the Hose ............................................................................................ 7

Warranty ......................................................................................................... 8

GENERAL INFORMATION

The Chameleon Retractable Hose System for central vacuums is designed

for home and light commercial interior installations. The Chameleon Valve

solves the challenge of storing and retrieving the long hose typically used

with central vacuums. Hoses are available in lengths up to 60’ to offer

maximum cleaning coverage and optimum valve location no matter the

ﬂoor plan of the home.

COMPLETING THE INSTALLATION

Once drywall work is complete, remove the plaster guard and secure valve

door to valve assembly with four screws (do not over tighten).

Red Cap

Installed

Multiple Valve Installation Tip:

It is necessary to leave the red plug

securely in place in all valves until

the hoses are installed to allow

the system to seal. Only a sealed

system will have the adequate

vacuum to retract the hose into a

valve when a hose is being installed.

Once the hose is installed in a valve,

the system will be sealed to allow

for proper vacuum.

INSTALLING THE HOSE INTO THE VALVE

NOTE: If a shorter hose is needed, the hose MUST be shortened on the

handle end, not the cuff end. Please refer to “Shortening the Hose” section

on the next page.

1. Lift the valve door and remove the red plug that is pressed into the

valve.

2. Turn central vacuum on using the on/off switch inside valve. Push the

hose cuff end into the valve until it clicks and stops. Rotate the hose

cuff 90-degrees to the left and partially cover the handle end of the hose

with hand. The hose will release and begin retracting into the tubing.

3. Once the hose is fully retracted, push the hose handle onto the rubber

ball and the vacuum will automatically turn off and seal the valve.

Repeat above steps for each additional valve.

SHORTENING THE HOSE

1. Locate the tabs on each side of the handle’s underside. (FIG. 1)

2. Use a screwdriver or ﬁngernail to press tabs in towards the hose to

release and remove the handle. (FIG. 1)

3. Keep the black locking collar on the hose. (FIG. 2)

4. Remove the clear barbed insert by pulling outward and unscrewing

(left-hand thread) or carefully slit hose below insert with razor knife to

remove. (FIG. 2)

5. Shorten the hose as needed.

6. Push the barbed insert into the hose, then slide the locking collar into

place. (FIG. 3)

7. Attach the nozzle by re-engaging the tabs on each side (push

outwards)—you should hear a “click." (FIG. 3)

FIG. 1

FIG. 2 FIG. 3

USING THE SYSTEM

1. Pull hose handle out, down and away from the valve. (FIG. 1)

2. Continue pulling the hose until you feel the end of the hose reach the

valve. You will hear and feel the hose end “click” into its locked position.

(FIG. 2)

3. Turn the system on using the on/off switch inside the valve to begin

vacuuming. The system can be used to vacuum dry messes. Optional

attachments may be used on the hose end to meet various cleaning

needs. (FIG. 3)

FIG. 1 FIG. 2 FIG. 3

STORING THE HOSE

1. With the system on, unlock the hose end by grabbing the hose

approximately 8-inches from the valve and rotate the hose to the left

until it releases. (FIG. 1)

2. Partially cover the handle end with hand to retract the hose. (FIG. 2)

3. Once fully retracted, push the handle end onto the rubber ball and the

system will automatically turn off. (FIG. 3)

FIG. 1 FIG. 2 FIG. 3

512 W. Gorgas St., Louisville, Ohio 44641

www.chameleonvac.com

All permanently installed components of the Chameleon Valve are warranted to be free from defects in

material and workmanship for a period of ﬁve (5) years under normal use and care as long as the original

purchaser own the home of the original installation or until the system is removed from its original

installation location, whichever occurs ﬁrst. In the event of a defect in a permanently installed component

of the Chameleon Valve, contact an Authorized Dealer to ensure the best quality repair and servicing. Upon

determination of a defect with a permanently installed component, H-P Products, Inc. will provide any

replacement parts to the Authorized Dealer at no cost to you. Repair or replacement of any permanently

installed defective part or parts shall be at the labor cost billed to you by the Authorized Dealer.

The Chameleon Hose is warranted to be free from defects in material and workmanship under normal use

and care for a period of three (3) years from original date of consumer purchase. In the event of a defect

in the Chameleon Hose, it will be repaired or replaced, at H-P Products' option, at an Authorized Dealer’s

location at no cost to you.

Limitations for Non-Residential Applications

In non-residential applications both permanently installed components of the Chameleon Valve and the

Chameleon Hose are warranted to be free from defects in material and workmanship for ninety (90) days

from original date of purchase.

THIS WARRANTY IS A SOLE AND EXCLUSIVE WARRANTY. ALL OTHER WARRANTIES INCLUDING IMPLIED

WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE EXCLUDED. THIS

WARRANTY COVERS ONLY LIABILITY AND RESPONSIBILITY DESCRIBED HEREIN AND THERE IS NO

LIABILITY FOR ANY CONSEQUENTIAL, INCIDENTAL OR SPECIAL DAMAGES ARISING FROM THE USE OF

THIS SYSTEM.

Some states do not allow the exclusion or limitation of warranties or limitation of incidental or

consequential damages, so the above exclusion may not apply to you. This warranty gives you speciﬁc legal

rights and you may have other rights that vary from state to state.

CHAMELEON RETRACTABLE HOSE SYSTEM WARRANTY

Indice

Manuali Aspirapolvere popolari di altre marche

Bissell

Bissell LittleGreen Proheat 1425 Series Manuale utente

Panasonic

Panasonic MC-YL637S147-AE Manuale utente

NEFF

NEFF N17XH10 0 Series Manuale utente

LG A9 Series Manuale utente

Oreck

Oreck Cordless Captura BK51700 Series Manuale utente

Kogan

Kogan KAVACROBVWA Manuale utente

Kränzle

Kränzle VENTOS 50 ID Guida utente

EVVO

EVVO Ai35 Manuale utente

DeWalt

DeWalt DWH200D Manuale utente

Pontec

Pontec Pondomatic Vacuum Cleaner Manuale utente

Cleanmaxx

Cleanmaxx PC-P007E Manuale utente

Exido

Exido 240-114 Manuale utente

RIDGID

RIDGID WD1685AU0 Manuale utente

Ezviz

Ezviz RE4P Manuale utente

STG global

STG global TANVAC HDV3000 Manuale utente

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Manuale utente

Factory

Factory M3340 Manuale utente

Shop-Vac

Shop-Vac VN92 SERIES Manuale utente