Champion Eseries Manuale
Installation/Operation Manual with Service Replacement Parts
2674 N. Service Road, Jordan Station
Ontario, Canada L0R 1S0
905/562-4195 Fax: 905/562-4618
Toll-free: 800/263-5798
3765 Champion Boulevard
Winston-Salem, NC 27105
336/661-1556 Fax: 336/661-1660
Toll-free: 800/858-4477
Issue Date: 4.23.15
Manual P/N 114896 rev. C
Printed in the USA
Machine Serial No.
Model EBD
E-series Blower Dryer Option
(Electric or Steam)
For all Rack Conveyor and
Upright Conveyor Dishwashers
COPYRIGHT © 2015All rights reserved Printed in the USA
For future reference, record your blower dryer information in the box below.
Model Number__________________________ Dishwasher S/N_______________________
Voltage________________Hertz_____________ Phase__________________
Service Agent __________________________________ Tel:______________________
Parts Distributor _________________________________ Tel:______________________
ATTENTION:
The model no., serial no., voltage, Hz
and phase are needed to identify your
machine and to answer questions.
The dishwasher machine data plate is
located on the side of the dishwasher
control cabinet.
Please have this information ready
if you call for service assistance.
National Service Department
In Canada: In the USA:
Toll-free: 800/ 263-5798 Toll-free: 800/ 858-4477
Tel: 905/ 562-4195 Tel: 336/ 661-1556
Fax: 905/ 562-4618 Fax: 336/ 661-1660
The USGBC and the CaGBC Member Logos are trademarks owned by the U.S. Green Building Council and The Canadian Green Building Council,
respectively, and are used by permission. The logos signify only that Champion Industries is USGBC member and CaGBC member; USGBC and
CaGBC do not review, certify nor endorse the products or services offered by its members.
http://www.championindustries.com/canada/register
REGISTER YOUR PRODUCT ONLINE
Make sure you are connected to the internet then enter the address below.
In the U.S.A
In Canada
http://www.championindustries.com/register
PRODUCT REGISTRATION
BY FAX
(336) 661-1660 in the USA
1-(800) 204-0109 in Canada
IMPORTANT IMPORTANT
Model Serial #
Date of Installation:
Company Name:
Telephone #: ( ) ---
Contact:
Address:
Address:
Telephone #:
Contact:
Installation Company:
(Street) Province Postal Code
FAILURE TO REGISTER YOUR PRODUCT MAY VOID YOUR WARRANTY
PRODUCT REGISTRATION CARD
COMPLETE THIS FORM AND FAX TO:
i
Revision History
Revision Revised Serial Number Revision
Date Pages Effectivity Description
3.29.11 All Engineered System Released First Edition
5.1.11 10-11, 14-15 --------------------- Corrected parts list replacing 2PDT relay with
3PDT relay
8.23.12 10-11, 14-15 J12073063 Changed piezo switches to electro-mechanical
4.23.15 12-13,16-17 J15033463 AddedmotorbracketforhighefciencyTEFCmotor
A revision might be a part number change, a new instruction, or other information that was not
available at print time. We reserve the right to make changes to these instructions without notice
and without incurring any liability by making the changes. Equipment owners may request a
revised manual, at no charge, by calling 1 (800) 858-4477 in the USA or by calling
1 (800) 263-5798 in Canada.
Revision History
ii
Limited Warranty
LIMITED WARRANTY
Champion Industries Inc. (herein referred to as Champion), 3765 Champion Blvd., Winston-Salem, North Carolina 27105,
and P.O. Box 301, 2674 N. Service Road, Jordan Station, Canada, L0R 1S0, warrants machines, and parts,
as set out below.
Warranty of Machines: Champion warrants all new machines of its manufacture bearing the name
"Champion" and installed within the United States and Canada to be free from defects in material and workman
ship for a period of one (1) year after the date of installation or fteen (15) months after the date of shipment by
Champion, whichever occurs rst. [See below for special provisions relating to glasswashers.] The warranty
registration card must be returned to Champion within ten (10) days after installation. If warranty card is not
returned to Champion within such period, the warranty will expire after one year from the date of shipment.
Champion will not assume any responsibility for extra costs for installation in any area where there are
jurisdictional problems with local trades or unions.
If a defect in workmanship or material is found to exist within the warranty period, Champion, at its election,
will either repair or replace the defective machine or accept return of the machine for full credit; provided;
however, as to glasswashers, Champion's obligation with respect to labor associated with any repairs shall end
(a) 120 days after shipment, or (b) 90 days after installation, whichever occurs rst. In the event that Champion
elects to repair, the labor and work to be performed in connection with the warranty shall be done during regular
working hours by a Champion authorized service technician. Defective parts become the property of Champion.
Use of replacement parts not authorized by Champion will relieve Champion of all further liability in connection
with its warranty. In no event will Champion's warranty obligation exceed Champion's charge for the machine.
The following are not covered by Champion's warranty:
a. Lighting of gas pilots or burners.
b. Cleaning of gas lines.
c. Replacement of fuses or resetting of overload breakers.
d. Adjustment of thermostats.
e. Adjustment of clutches.
f. Opening or closing of utility supply valves or switching of electrical supply current.
g. Cleaning of valves, strainers, screens, nozzles, or spray pipes.
h. Performance of regular maintenance and cleaning as outlined in operator’s guide.
i. Damages resulting from water conditions, accidents, alterations, improper use, abuse,
tampering, improper installation, or failure to follow maintenance and operation procedures.
j. Wear on Pulper cutter blocks, pulse vanes, and auger brush.
Examples of the defects not covered by warranty include, but are not limited to: (1) Damage to the exterior or
interior nish as a result of the above, (2) Use with utility service other than that designated on the rating plate,
(3) Improper connection to utility service, (4) Inadequate or excessive water pressure, (5) Corrosion from
chemicals dispensed in excess of recommended concentrations, (6) Failure of electrical components due to
connection of chemical dispensing equipment installed by others, (7) Leaks or damage resulting from such
leaks caused by the installer, including those at machine table connections or by connection of chemical
dispensing equipment installed by others, (8) Failure to comply with local building codes, (9) Damage
caused by labor dispute.
Warranty of Parts: Champion warrants all new machine parts produced or authorized by Champion to be free
from defects in material and workmanship for a period of 90 days from date of invoice. If any defect in
material and workmanship is found to exist within the warranty period Champion will replace the defective
part without charge.
DISCLAIMER OF WARRANTIES AND LIMITATIONS OF LIABILITY. CHAMPION'S WARRANTY IS ONLY TO THE EX-
TENT REFLECTED ABOVE. CHAMPION MAKES NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING,
BUT NOT LIMITED, TO ANY WARRANTY OF MERCHANTABILITY, OR FITNESS OF PURPOSE. CHAMPION SHALL
NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. THE REMEDIES SET OUT ABOVE ARE
THE EXCLUSIVE REMEDIES FOR ANY DEFECTS FOUND TO EXIST IN CHAMPION DISHWASHING MACHINES AND
CHAMPION PARTS, AND ALL OTHER REMEDIES ARE EXCLUDED, INCLUDING ANY LIABILITY FOR INCIDENTALS
OR CONSEQUENTIAL DAMAGES.
Champion does not authorize any other person, including persons who deal in Champion dishwashing machines
to change this warranty or create any other obligation in connection with Champion Dishwashing Machines.
iii
Revision History ...........................................................................................................i
Limited Warranty ...........................................................................................................ii
Model Descriptions ...........................................................................................................iv
Installation ..............................................................................................1
Receiving....................................................................1
Mounting the Blower Dryer to the Dishwasher ...........2
Electrical Connections................................................4
Steam Heat Steam Connection..................................5
Steam Heat Condensate Connection.........................5
Initial Start-up..........................................................................................6
Installation Check List.................................................6
Blower Dryer and Dishwasher Control Panels............6
Operation................................................................................................................7
Normal Blower Dryer Operation..................................7
Blower Dryer Shut-down Operation............................7
Cleaning, Maintenance and Troubleshooting..............................................8
Service Replacement Parts.......................................................................9
Electrical Schematic..............................................................................................21
Table of Contents
Table of Contents
EBD Blower Dryer
iv
Model Description
Model Description
EBD Blower Dryer
Electric 12KW heater with Automatic Shut-off
2 HP Blower Motor
Steam 85 lbs/hr at 15-30 PSI with Automatic Shut-off
2 HP Blower Motor
1
NOTE:
The installation of the Blower Dryer must be performed by qualified service personnel.
Problems due to improper installation are not covered by the Warranty.
NOTE:
The installation of the blower dryer must comply with all local electrical, plumbing, safety
and health codes.
NOTE:
The Blower Dryer was fully tested before leaving the factory. It was disassembled
from the dishwasher and shipped on its own pallet.
CAUTION:
Be careful when lifting and moving the blower dryer to prevent damage to the unit.
1. Inspect the blower dryer and pallet for signs of shipping damage.
2. Turn to the front of this manual and follow the instructions to register your
blower dryer and dishwasher online. The blower dryer does not have a
serial number; therefore, the blower dryer will be registered when the
dishwasher is registered.
3. Move the blower dryer and the dishwasher near their permanent locations.
4. Compare the installation site utility connections with the machine utility
connections and make sure they are the same.
5. Follow the installation instructions contained in this manual to mount the
blower dryer to the top of the dishwasher.
6. Follow the dishwasher Installation/Operation Instructions Manual that was
shipped with the dishwasher to install the dishwasher.
7. Follow the operation instructions contained in this manual to operate the
blower dryer.
Installation
Receiving
2
The blower dryer is shipped separately on its own pallet . Refer to the diagrams below and on
the next page to mount the blower dryer to the top of the dishwasher.
To mount the blower dryer:
1. Refer to the diagram below noting the placement of (2) 2 X 4 boards to lift the BD when
using a forklift.
2. Use 4 men to lift and place the unit on the dishwasher if a forklift is not
available. The BD weighs 225 lbs. The 2 X 4's are not used if placing manually.
Installation
Mounting the Blower Dryer to the Dishwasher
! CAUTION !
Use extreme caution and follow all safety procedures when lifting and
moving the blower dryer assembly.
2 x 4 board placement when lifting the blower dryer with a forklift.
10-1/2" 28-1/2" 25"
36"
28-1/2"
Side
Front
39" 2" x 4" x 36" Lg. Board
Left to Right Operation Shown
Altri manuali per Eseries
2
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Champion Asciugatrice
