5
3. Installation Instructions
This section describes how to set up your fire.
BEFORE YOU START
1. Ensure that all packing items are removed (read any warning labels
carefully) and retain all packing for possible future use e.g. in the event of
moving house or returning the appliance to your supplier.
2. Before connecting to the mains supply, check that the supply voltage is
the same as that stated on the appliance.
INSTALLATION
Electric Fire Baskets: Place the appliance against a wall.
Connect the power cable to the appropriate power connector at the back
of the appliance and plug the power cable into a 110 volt outlet.
Do not yet switch the appliance on.
Electric Stoves: Place the stove in to position allowing a minimum of 5”
all around the stove for ventilation.
Connect the power cable to the appropriate power connector at the back
of the fire and plug the power cable into a 110 volt outlet.
Do not yet switch the appliance on.
Connecting theTransducer Unit + Bulbs
1. Release the two red tabs by turning them by 90 degrees (see Fig.1).
2. Lift out the Reservoir Nozzle (Fig.2).
3. Insert bulbs into bulb holders (Fig.3), carefully locating the pins into
the holes (Fig.4).
4. Push bulbs firmly into place.
5. Place theTransducer Unit into the reservoir and join the cable to the
connector on the reservoir (Fig 5).
6.To ensure that theTransducer Unit is correctly placed in the reservoir,
the tab on theTransducer Unit should be lined up with the moulded
recess in the reservoir (Fig 5a).
7. Ensure that the cable is not placed above the disc on theTransducer
Unit (Fig 5b).To prevent the cable becoming pinched between the nozzle
and the reservoir, place the cable in the slot in the wall of the reservoir.
8. Replace the Reservoir Nozzle and secure it by turning the two red tabs
by 90 degrees (Fig 6).
