Ciar PS10BSA Manuale utente
ENG
ITA
DESCRIPTION: -
PREPARED BY: M.CHIARAVALLOTTI
DOC.COD.: N470010186
CHECKED BY: C.UGUCCIONI APPROVED BY: A.ROSATI
REV.Nr.: 1.0 DATE: 09/01/2015
Kit PS10BSA 2,2Ah - Li-Ion
Instruction Manual / Manuale d’istruzione
PS10BSA
Power supply unit
PS05
for PS10BSA
Power supply unit
PS10 for PS10BSA
ENG
DESCRIPTION: -
PREPARED BY: M.CHIARAVALLOTTI
DOC.COD.: N470010174
CHECKED BY: C.UGUCCIONI APPROVED BY: A.ROSATI
REV.Nr.: 1.2 DATE: 06/11/2014
Kit PS10BSA 2,2Ah - Li-Ion
Instruction Manual
Thank you for having purchased one of our products.
Before using the device, read the instruction manual carefully,
paying particular attention to the Precautions for Use.
Always keep the manual close at hand.
PS10BSA
Power supply unit
PS05
for PS10BSA
Power supply unit
PS10 for PS10BSA
Contents
Precautions for use 6
General 6
Disclaimer 6
Storage and usage conditions 6
Warning 6
Recommendations for the nal user 7
Guarantee 8
PS05 power supply for charging 9
Fitting the plug 9
Removing the plug 9
Characteristics of supply unit type PS05 for PS10BSA 10
Precautions for use of the supply unit for PS10BSA 11
Precautions for use 11
Characteristics of transformer type: PS10 12
Instruction for PS10BSA recharging 13
Preamble 13
Standard charging procedure 13
Under Discharge 14
Auxiliary accessoires for the battery kit 14
Kit Power On/Off 14
Kit Power Selector 14
Assembly of Kit PS10BSA 15
PS10BSA Floor version 15
PS10BSA Surface-mounted version 15
Characteristics of battery type: PS10BSA 2.2Ah - Li-Ion 17
Procedura di ricarica standard 30
Sotto scarica 31
Accessori ausiliari per il kit batteria 31
Kit Power On/Off 31
Kit Power Selector 31
Assemblaggio Kit PS10BSA 32
PS10BSA Versione a pavimento 32
PS10BSA Versione ssabile ad una supercie 32
Caratteristiche batteria tipo: PS10BSA 2.2Ah - Li-Ion 34
ENG
Important
The purpose of the list of precautions reported below is to prevent injury and/or damage
and must be read carefully.
The following WARNING symbols are used to illustrate the degree of danger or damage/
injury.
Symbols and their meanings
DANGER — Possibility of serious injury or death.
WARNING — Possibility of damage or injury.
Damage is intended as that caused to furniture while injury refers to
persons and animals in general.
Examples of symbols
The triangular symbol indicates a “Warning”. The warning is explained by
means of a written explanation or images inside or near to the symbol. In
this specic case, the symbol on the left indicates "Danger of electrocution”.
The circle with diagonal line indicates a "Prohibition" or "No" sign. The
warning is explained by means of a written explanation or images inside
or near to the symbol. In this specic case, the symbol on the left indicates
"Do not dismantle the product”.
This symbol signies “Requirements that must be respected”. The
warning is explained by means of a written explanation
or images inside or near to the symbol.
In this specic case the symbol indicates “General requirements”.
page 6
Precautions for use
Storage and usage conditions
General
Disclaimer
Warning
The device is not suitable for use by children or disabled persons unless appropriately supervised by a
responsible adult able to use the device itself in complete safety. Children must not be allowed to play with the
device.
C.I.A.R. will not be held liable for its product if its use does not comply with the following requirements:
- The working cycle when used with Ciar actuators is 2 minutes work with 5 minutes pause.
- Only C.I.A.R. authorised personnel can dismantle the various parts of the kit.
- Do not cut or touch any wires in the kit with sharp objects.
- Do not connect the kit other than in the manner described in this manual.
- Do not use any parts of the kit with devices other than those indicated in this manual.
- Do not connect the power supply cable to a mains supply of voltage different to that indicated in
this manual and on the labels attached to the device.
- Do not wet the parts making up the kit.
- Do not place any metal objects near any parts of the kit while it is plugged into the mains.
- Do not use the device other than in a domestic environment.
- Do not open the device for any reason. Any faulty or broken parts must be returned to the
manufacturer or an authorised service centre or placed in the hands of
a person possessing similar qualications, avoiding all possible risks.
- Do not use in damp environments or in the presence of heat sources (ovens or direct sunlight).
- In the case where the power cable is not detachable from the device and has been
damaged, it can be replaced by the manufacturer, an authorised service centre or
a person possessing similar qualications, avoiding all possible risks.
STORAGE AND USAGE CONDITIONS
Working environment:
Temperature: between 0°C and 45°C
Humidity: between 20 and 70% (without condensation)
Storage environment:
Temperature: between -20°C and +45°C
Humidity: between 10 and 70% (without condensation)
- If the device is to be left unused for a long period of time, the batteries will slowly self-discharge and
the resulting over-discharge may damage the batteries themselves. It is advisable to fully charge the batteries
at least once every 3 months.
- If a new battery is not used for approximately one month after the last recharge, the remaining charge is
approximately half the nominal charge.
The constructor of the nished product in which the motor kit and eventual battery kit will be installed must
compile an instruction manual for the use of his own product.
The content and safety notes of this manual can be freely used for the nal product.
Please keep the PS10BSA disconnected from load and / or control devices during storage or transportation to
avoid undesired action or discharge.
page 7
ENG
Recommendations for the nal user
Do not separate, open or dismantle secondary cells, batteries or the device as a whole.
Do not expose the cells or batteries to heat or re. Avoid storage in direct sunlight.
Do not short-circuit the cells, batteries or the device itself.
Do not install the cells, batteries or the device itself in a closed container (boxes, metal containers, wooden
containers, etc.) without protecting the positive or negative poles of the cells or the metal connector of the
battery pack, in that these could lead to accidental short-circuits.
Do not remove the cells or batteries from the battery pack for other uses.
Do not subject the cells, batteries or the device itself to mechanical shocks (avoid dropping the battery pack,
hitting it when on the ground and do not place any objects on top).
Should any chemical substances leak from the battery pack, avoid all contact with the substance. In the case of
contact, wash the affected parts immediately in abundant quantities of water and seek medical help.
Do not use chargers or power supply units other than those specied in this manual.
Keep the battery container out of reach of children.
Only use components approved by Ciar.
Keep the battery pack clean and dry.
Avoid soiling the connections on the device. If necessary, clean using a dry cloth.
The batteries must be charged before use. To charge the batteries, follow the instructions written in this manual.
Do not leave the battery pack connected when not being used for long periods.
After a long period of storage, several charging cycles may be necessary to obtain the maximum duration
of the charge.
The batteries perform at their best between 5 and 20°C.
page 8
Guarantee
C.I.A.R. guarantees its product against manufacturing defects for a period of two years from the date of
purchase by the nal user. During the guarantee period, the company will, at its own discretion, repair or
replace the defective product.
The kit is not guaranteed against defects resulting from:
- Unsuitable or inappropriate maintenance by the customer
- Modications, improper or unauthorised use
- Use of the kit under unsuitable operating conditions
- Abuse of the specied work cycle
- Damage during shipment caused by unsuitable packaging.
Due to their nature, rechargeable batteries have a limited life-span and are characterised by a gradual loss of
power over time.
This natural degradation in performance and the progressive loss of power are not covered by any form of
guarantee.
STANDARDS
The product has been designed and manufactured in accordance with:
2004/108/EC AND SUBSEQUENT AMENDMENTS “EMC”
- CEI EN55014-1
- CEI EN 55014-2
- CEI EN 61000-3-3
- CEI EN 61000-3-2
- EN 62233
2006/95/EC AND SUBSEQUENT AMENDMENTS “LOW VOLTAGE”.
- EN 60950-1
- EN 62133
Directive 2006/66/EC of 06/09/2006 and amendment 2008/103/EC of 19/11/2008.
Battery registration number IT12090P00002923
page 9
ENG
PS05 power supply for charging
Warning
Before tting the mains plug to the device, select the plug
type appropriate to the country of use (see chapter Main
Power Supply Unit Characteristics for the PS10BSA).
1 - Fully insert the selected plug in the housing of the
power supply unit until it clicks into position (photo 1, 2
and 3).
2 - Press the plug locking tab (photo 4)
3 - Keeping the tab pressed, push the plug outwards
(photo 5) until it completely separates (photo 6).
photo 1
photo 4
photo 2
photo 5
photo 3
photo 6
Removing the plug
Fitting the plug
page 10
Technical characteristics:
Input voltage: 100-240 Vac
Input frequency: 50/60Hz
Output voltage: 33Vdc
Output current: 500mA
Output connection:
Output cable: 150 cm with DC plug 5.5x2.5
Power supply unit: switching type
Device dimensions: 5 x 7.7 x 4 cm
Characteristics of supply unit type PS05 for PS10BSA
European
plug
Label
English
plug
-+
Indice
Lingue:
