Cirro Evolve Manuale
Thank you for purchasing the Cirro Evolve
Temperature Controlled (TC) Module.
We are sure that you will enjoy the vaping experience
and the taste of our new premium range of eLiquids Cirro
Blends.
This information leaflet contains important safety and usage
information, so please ensure you read through it carefully.
Please make sure the following contents are included in the
package before using.
Pack Content:
1. 2ml glass tank
2. 0.2Ω coil
3. USB charger
4. 1100 mAh battery
Features:
• Temperature control
• Easy to use temperature
adjuster
• Adjustable airflow
• Top filling tank
• Vape while charging
Specification:
• Tank volume: 2.0ml
• Coil resistance: 0.2Ω
• Coil material: Nickel200
• Temperature and power:
Low, Medium, High
• Battery capacity: 1100 mAh
Mouthpiece
Tank
Coil
Air flow valve
Power button
Battery
TC rotary dial
Coils, tanks and accessories available at www.10motives.com
Recommended for use with Cirro Blends 6mg Liquids
Getting Started:
1. Fully charge the device (as per
the instructions in the “Charging
the Battery”section).
2. Fill the tank (as per the
instructions in the “Filling
the Tank” section).
3. Turn on the device by pressing
the power button 5 times within
2 seconds.
4. To vape, press and hold the
power button as required.
Note: if the button is pressed
for longer than 10 seconds, the
unit will automatically
shut down.
5. To reactivate, release the power
button and turn on the device
by pressing the power button 5
times within 2 seconds.
6. Turn off the device by pressing
the power button 5 times within
2 seconds.
Charging the Battery:
• When the battery voltage drops
below 3.4V, the LED light will
flash 10 times and the device
will turn off.
• The battery will require
charging, which takes
approximately 2 hours.
• Connect the battery to a
computer or compatible 5V/1A
mains adapter via the supplied
USB charger. Once connected,
the LED light will flash 5 times.
• When fully charged the LED will
flash three times and go out.
• The Evolve can be vaped while
it is charging.
• Do not leave the battery
unattended whilst charging and
never charge it overnight.
If the product is not used for 10
mins, it will automatically lock down.
Alternatively, press and hold the
activation button for more than 10
seconds to lock manually.
To reactivate the product, press the
activation button 5 times within 2
seconds.
Filling the Tank:
1. With the tank attached to the
battery, firmly grip the
tank section and unscrew the
mouthpiece anti-clockwise.
2. Tilt the tank to 45 degrees and
pour the eLiquid down the
sides of the tank. Ensure
that no eLiquid flows into the
central air hole.
3. To avoid any leakage, ensure
that your tank is not overfilled –
only fill to the maximum
tank volume of 2ml (marked on
tank window).
4. Replace the mouthpiece onto
the tank.
5. Allow the tank and coil to prime
for 5 minutes before use.
6. You should refill
your tank
before your
eLiquid
drops
below
the minimum fill point.
Keep
upright and
attached
to battery
when filling
the tank
Keep tank
upside
down and
leave cap
on when
replacing
the coil
Replacing the Coil:
1. Depending on your personal
usage, the coils should
be replaced approximately
every 7-10 days or if you notice
a change in vape or taste.
2. Firmly grip the knurled part
of the airflow valve of the
tank to remove the tank
from the battery section. Do
not detach the battery
by holding glass tank section
as this may cause eLiquid to
leak from the tank.
3. Turn the tank upside down and
unscrew the base of the tank
(airflow valve) from the
main tank.
4. Unscrew the old coil from the
tank and replace with a
new coil.
5. Securely reattach the base of
the tank (airflow valve)
to the tank, avoiding
overtightening.
6. Allow the tank and coil to prime
for 5 minutes before use.
Coils, tanks and accessories available at www.10motives.com
Recommended for use with Cirro Blends 6mg Liquids
Altri manuali Cirro Vaporizzatore
