171.227, 171.228 User Manual
Multiple Flown Array
For multiple flown line-array, installation is similar to
that of a single array with sub cabinets coupled
together and passive units all flown in a single,
longer array.
With the uppermost sub unit attached to its flying
frame, secure the 4 x M8 eyebolts for flying.
Undo the 2 x M5 thumb screws at the bottom of the
sub unit and remove the Active-Passive Link bracket.
Subsequent sub units are attached underneath by
removing the flying frame(s) and aligning the 4 top
corner mounting holes with corresponding holes on
the bottom of the sub unit above it. These are
secured through using the 4 x M5 thumb screws
accordingly.
Connection of passive units from the bottom sub unit
is executed in the same way as for a single line
array, with each group of 4 passive units linked in a
single line-array.
Floor-standing Stack
Where flying or ceiling mounting is not possible, it may
be useful to arrange the CLA-300 as a free-standing
stack on the floor or on a stage. In this orientation, the
sub unit sits on its flying frame on the floor and the
passive units are splayed upwards above the sub unit.
Prior to assembly, do not attach the 4 x M8 eyebolts to
the flying frame. If the frame is likely to damage the
floor surface, protect with rubber or other scratch-
resistant material.
Assemble passive units above the sub in the same
manner as for a standard flown array shown above but
inverted. Splayed angle adjustment may be used for
venues with raised rear seating areas (e.g. theatres)
