R
Page 3
Place the round tubes (1 & 2), the tube connector (11),
the aluminum connector (8) and the two cylinder head
screws (5) as shown in the picture. Please make sure
that the round recess of the connector (8) faces
outwards.
Insert the tube connector (11) into the ends of the two U-shaped
round tubes (1) without transverse hole.
Now insert the aluminum connector (8) into the ends of the
two U-shaped round tubes (1) with transverse hole.
Thread the appropriate number of shower curtain rings onto the
U-shaped round tubes (1). Of course, you can also clip on the shower
curtain rings at a later date. Then connect both ends of the U-shaped
round tubes (1) in a fl ush manner.
Carefully screw in the four cylinder head screws (5) each with one
washer (7) by hand. To fi nd the correct mounting height for the
holder (3 & 4), please refer to the dimensional drawing in the
supplementary sheet. Tighten the four cylinder head screws (5)
evenly with the hexagon key (9) until the holder can no longer
slide downwards. The height can easily be corrected at a later
point in time by loosening the screws.
Insert the tube connector (11) into the ends of the two U-shaped
curtain rings at a later date. Then connect both ends of the U-shaped
round tubes (1) in a fl ush manner.
9
11
Please check whether the holder (3 & 4) is positioned
parallel to the wall. Corrections can be made by turning
the joint feet (10).
7
8
10
6
