Clevo P170EM Manuale utente

Disassembly

Removing the Battery 2 - 5

2.Disassembly

1. Turn the computer off, and turn it over.

2. Slide the latch in the direction of the arrow (Figure 1a).

3. Slide the latch in the direction of the arrow, and hold it in place (Figure 1a).

4. The battery may be levered up at point (Figure 1b).

5. Lift the battery out of the compartment (Figure 1c).

Figure 1

Battery Removal

Disassembly

2 - 14 Removing the Secondary System Memory (RAM)

2.Disassembly

1. Turn off the computer, and turn it over, remove the battery (page 2 - 5) and the component bay cover.

2. Remove the top cover module (Figure 10a).

3. Remove screws - (Figure 10a).

4. Carefully lift the keyboard up, being careful not to bend the keyboard ribbon cable (Figure 10c).

Figure 10

RAM Module

Removal

• 5 Screws

a. b.

21 4

Disassembly

Removing the Secondary System Memory (RAM) 2 - 15

2.Disassembly

5. Disconnect the keyboard ribbon cable from the locking collar socket by using a small flat-head screwdriver

to pry the locking collar pins away from the base. (Figure 11e).

6. Remove the keyboard and the memory sockets & will be visible (Figure 11f).

7. Gently pull the two release latches ( ) on the sides of the memory socket(s) in the direction indicated below

(Figure 11g).

8. The RAM module will pop-up, and you can remove it.

9. Pull the latches to release the second module if necessary.

10. Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.

11. The module’s pin alignment will allow it to only fit one way. Make sure the module is seated as far into the slot as it

will go. DO NOT FORCE the module; it should fit without much pressure.

12. Press the module in and down towards the mainboard until the slot levers click into place to secure the module.

13. Replace the bay cover and screws.

14. Restart the computer to allow the BIOS to register the new memory configuration as it starts up.

Figure 11

RAM Module

Removal (cont’d.)

Disassembly

2 - 16 Removing the Wireless LAN Module

2.Disassembly

1. Turn off the computer, remove the battery (page 2 - 5) and the keyboard (page 2 - 10).

2. The Wireless LAN module will be visible at point under the keyboard (Figure 12a).

3. Carefully disconnect cables - , then remove screw from the module socket (Figure 12b).

4. The Wireless LAN module will pop-up (Figure 12c).

5. Lift the Wireless LAN module (Figure 12d) up and off the computer

Figure 12

Wireless LAN

Module Removal

• 1 Screw

Altri manuali per P170EM

Manuali Computer portatile popolari di altre marche

HP ze2401xt - Pavilion Notebook PC Manuale utente

Velocity

Velocity NoteMagix M10 Manuale utente

Dell

Dell Alienware 17 R2 Manuale utente

Toshiba

Toshiba A105-S2236 Manuale utente

HP ENVY 17 Manuale

Winbook

Winbook LM Manuale utente

Dell

Dell Inspiron 1464 Manuale utente

Dell

Dell Inspiron 15R 5537 Manuale utente

HP PROBOOK 4520S Manuale

Dell

Dell Latitude ATG D620 Manuale utente

Sony

Sony VAIO PCG-FX270 Manuale utente

Dell

Dell Latitude 7310 Manuale utente

Dell

Dell Precision GU806 Manuale utente

Sony

Sony VAIO PCG-R505JLK Manuale utente

Lenovo

Lenovo THINKPAD X32 Manuale utente

HP Compaq tc4200 Guida rapida

Toshiba

Toshiba mini NB300 Manuale utente

Lenovo

Lenovo ThinkPad X201 Tablet Manuale