WWW.CLF-LIGHTING.COM 3.0
Do not expose the fixture to rain or moisture
Refer any service operation not described in this manual to a qualified technician.
Socket outlets used to supply the fixture with power or external power switches must be located near the fixtures and
easily accessible so that the fixtures can easily be disconnected from power.
Do not operate the fixture if the ambient temperature (Ta) exceeds 40°C.
The exterior of the fixture becomes hot during use. Avoid contact by persons and materials.
Allow the fixture to cool for at least 10 minutes before handling.
Keep all combustible materials (e.g. fabric, wood, paper) at least 100 mm away from the fixture.
Keep flammable materials well away from the fixture.
Ensure that there is free and unobstructed airflow around the fixture.
Do not illuminate surfaces within 200 mm of the fixture.
Do not attempt to bypass thermostatic switches or fuses.
If you relay power from one fixture to another using power throughput sockets, do not connect more than ten the
fixture in total to each other in an interconnected chain.
Do not stick filters, masks or other materials onto any optical component.
Do not modify the fixture in any way not described in this manual
Do not use fixture on a dimmer
Do not look continuously at LEDs from a distance of less than 3 meters from the front surface of the fixture without
protective eyewear such as shade 4-5 welding goggles. At less than this distance, the LED emission can cause eye
injury or irritation. At distances of 3 meters and above, light output is harmless to the naked eye provided that the
eye’s natural aversion response is not overcome.
Do not look at LEDs with magnifiers, telescopes, binoculars or similar optical instruments that may concentrate the
light output.
Ensure that persons are not looking at the LEDs from within 3 meters when the product lights up suddenly. This can
happen when power is applied, when the product receives a DMX signal, or when SERVICE menu items are
selected.
Fasten the fixture securely to a fixed surface or structure when in use.
Ensure that any supporting structure and/or hardware used can hold at least 10 times the weight of all the devices
they support.
Allow enough clearance around the fixture to ensure that it cannot collide with an object or another fixture when it
moves.
Check that all external covers and rigging hardware are securely fastened.
Block access below the work area and work from a stable platform whenever installing, servicing or moving the
fixture.
Do not operate the fixture with missing or damaged covers, shields or any optical component.
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
PROTECTION FROM BURNS AND FIRE
PROTECTION FROM INJURY
Connect only other the fixture to fixture power output sockets. Do not connect any other type of device to these
sockets.
lDo not connect any other type of device to these sockets.
