CNB LXC2050VR Manuale utente

LXC2050VR

Network Weatherproof Camera

Rev.1.1 (Sep. 2014) 2

Caution

Any changes or modifications in construction of this device which are not explicitly

approved by the party responsible for compliance could void the user’s authority to

operate the equipment.

Note

This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generate, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into and outlet on a circuit different from that to which

the receiver is connected

 Consult the dealer or an experienced radio/TV technician for help.

Directions

Be careful not to cause any physical damage by dropping or throwing LXC2050VR. Especially

keep the device out of reach from children.

Do not disassemble LXC2050VR. No After Service is assumed when disassembled.

Use only the power adapter provided with LXC2050VR.

Be careful to prevent moisture or water penetration into the unit. Particular attention is

needed when installing LXC2050VR. The screw holes for the installation screws and pipe

should be maintained water tight during the whole life time of the product.

All the electrical connection wires running into the unit should be prepared so that water from

the outside cannot flow into the unit through the surface of the wires. Penetration of the

moisture through the wire for extended period can cause malfunction of the unit or

deteriorated image.

Rev.1.1 (Sep. 2014) 3

Contents

1. Introduction .............................................................................................................................................. 4

1.1. Overview ............................................................................................................................................. 4

1.2. Specification ........................................................................................................................................ 5

1.3. Applications of LXC2050VR................................................................................................................. 6

2. Product Description ................................................................................................................................. 7

2.1. Contents ............................................................................................................................................. 7

2.2. Product Preview .................................................................................................................................. 7

2.3. Physical description............................................................................................................................. 8

2.3.1. Hardware Designation ............................................................................................................... 8

2.3.2. Dimension ................................................................................................................................. 9

2.3.3. Inside ...................................................................................................................................... 10

2.3.4. Zoom, Focus Lever ................................................................................................................. 11

2.3.5 External Connector................................................................................................................... 12

3. On Site Installation ................................................................................................................................. 13

4. Getting Started ....................................................................................................................................... 14

4.1. PC Requirement................................................................................................................................ 14

4.2. Quick Installation Guide ..................................................................................................................... 14

4.2.1. Connect PC and LXC2050VR to network. ................................................................................ 14

4.2.2. Install IP installer and set IP parameters on LXC2050VR ......................................................... 15

4.2.3. Remote video connection to LXC2050VR ................................................................................ 18

4.2.4. Additional settings through connection to the Admin Page ....................................................... 19

5. Trouble Shooting ................................................................................................................................... 20

5.1. No power is applied ........................................................................................................................... 20

5.2. Cannot connect to the Video ............................................................................................................. 21

5.3. Windows Vista or Windows 7............................................................................................................. 22

5.4. Technical Assistance ......................................................................................................................... 25

Rev.1.1 (Sep. 2014) 4

1. Introduction

1.1. Overview

LXC2050VR is multi-codec (H.264, MJPEG) IP camera (or network camera) built with embedded software and

hardware technology in pancake housing. It enables real time transmission of video of up to 1080P. Remote

clients can connect to LXC2050VR for the real time video data through various client solutions running on PC or

smart device.

LXC2050VR is specialized in video transmission which economic and practical products removing sensor,

replay, etc and the videos can be only available in the field and place where needed.

Embedded PoE (Power over Ethernet, IEEE 802.3af) will enable the owner to reduce TCO (Total Cost of

Ownership) by reducing on-site wiring works for the installation.

Rev.1.1 (Sep. 2014) 5

1.2. Specification

Camera

Image sensor Progressive scan 1/2.9 inch CMOS 2.0M pixels

Full resolution 1,920 x 1,080 pixels (Full HD)

Min. illumination 0.2Lux (Color, DSS On), 0.00 Lux (IR LED On)

S/N Ratio 50dB or more

White Balance Auto

DSS Supported

WDR Off/ON

Lens Built-in Varifocal Lens f=2.8-12mm F1.4

Day & Night Supported (TDN & IR LED)

IR LED 42EA (850nm, 30°) Max. 30m

Video

Compression method Simultaneous Dual Codec (H.264 / MJPEG)

Resolution 1920x1080@30fps

Multi-Profile Streaming - 3 simultaneous video profiles

- Select the codec type, resolution and frame rates for each profile.

Intelligent Bit-Rate Control Hybrid Bit Rate control (VBR+CBR)

Image Setting Text overlay, Privacy mask

Motion detection 3 regions

Video Output Select NTSC/PAL 1.0Vp-p (RCA type on board, 75Ω, composite)

Network

Network Protocol

- IPv4/v6, TCP, UDP, IGMP, ICMP, ICMPv6, ARP, RARP, PPPoE, RTCP

- RTP, RTSP, SDP, HTTP, HTTPS, SMTP, FTP, DHCP, UPnP

- NTP, DNS, DynDNS, SOCKS

Dynamic IP Supported (through management server)

Security - User ID & Password protection, IP address filtering

- HTTPS encryption, Digest Authentication, User Access Log

Streaming method

- RTSP streaming with proprietary format for control informations

- Standard RTSP streaming

- HTTP streaming

External Terminals

LAN 10/100BaseT LAN (auto MDIX)

Power DC 12V input

Factory Reset Supported

Rev.1.1 (Sep. 2014) 6

Alternate Power

Standard PoE IEEE802.3af Supported

Alarm & Event

Intelligent Video Motion Detection

Alarm Triggers Intelligent Video

Alarm Events video file upload(FTP), still Image(Email)

Alarm Buffer (Video) configurable Pre-alarm (5~10 sec) & Post-alarm (10~30 sec)

Client Software

NVR2 64ch@D1 (free of charge)

Mobile App. Android, iOS (free of charge)

Miscellaneous

Operating Temperature -10



C ~ 50



Operation Humidity 8~80% RH

Power DC 12V Max. 6W

Dimensions 91.6(W) x 89.8(H) x 284.8(L)

Weight Approx. 1kg

Approvals FCC, CE, KCC, RoHS

Package information IP camera, CD (User’s guide, Software…)

Optional Items

Adapter DC 12V, 2A

1.3. Applications of LXC2050VR

 Security surveillance (buildings, stores, manufacturing facilities, parking lots, banks, government facilities,

military, etc.)

 Remote monitoring (hospitals, kindergartens, traffic, public areas, etc.)

 Weather and environmental observation

Rev.1.1 (Sep. 2014) 7

2. Product Description

2.1. Contents

Please make sure that no contents listed below are missing in the package.

Contents Description Remarks

LXC2050VR IP camera LXC2050VR main unit

GUIDE PATTERN Guide Pattern

CD Software & User’s Guide

Accessory

Wall Anchors 4EA

SCREW 4EA

L Wrench 1EA

Video Cable 1EA

SUNSHEILD AND SCREW 1EA

2.2. Product Preview

LXC2050VR IP-Installer CMS Software (NVR2)

IP Weatherproof Camera PC software to allocate an IP

address to the IP Camera

PC software to view and record the

streaming data transmitted from IP

camera.

(Simultaneous support of up to 64

IP cameras@D1)

Rev.1.1 (Sep. 2014) 8

2.3. Physical description

Complete System

Figure 2-1. External view of LXC2050VR

① MegaPixel Vari-Focal Lens

② IR Illuminator : automatically illuminates depending on the light intensity

③ CDS Sensor

④ Screws (front-4EA & rear-4EA) : Sets the front and back cap

⑤ Sunsheild

⑥ Sunsheild fixing Screw : fixes the Sunsheild of the camera

⑦ Rotate adjusting Bolt : fixes the rotate angle of the camera

⑧ Tilt adjusting Screw : fixes the tilt angle of the camera

⑨ Pan adjusting Screw : fixes the pan angle of the camera

⑩ FRONT BODY

⑪ ZOOM & FOCUS Lever

⑫ GASKET(Video Out, Factory Reset Button, Power LED, Link/Act LED)

⑬ REAR-BODY

Rev.1.1 (Sep. 2014) 9

Figure 2-2. Dimension

Rev.1.1 (Sep. 2014) 10

Figure 2-3. GASKET

① Video Out : Use this output to monitor the analog video signal while installing.

(Select Video Out at menu screen to enable this output)

② Factory Reset Button : Press and hold for more than 5 seconds while power is on to recall

factory default settings

③ Power LED : Lights up Red when 12V DC power is connected.

④ Link/ACT LED : Lights up Yellow when the network is properly connected.

Lights up Yellow when the network camera is connected to 100Mbps LAN. Will not light up at

10Mbps LAN.

Indice

Manuali Telecamera di rete popolari di altre marche

Airsight

Airsight XX36A Manuale utente

Canon

Canon VB-H43 Manuale utente

Digimerge

Digimerge DNB6300V Manuale utente

Axis

Axis Q1604-E Manuale utente

Vivotek

Vivotek SD9363-EHL Manuale utente

Axis

Axis M1065-LW Manuale utente

Surveon

Surveon CAM4210 Manuale utente

Axis

Axis P1435-E Manuale utente

Surveon

Surveon CAM3260 Manuale utente

Edimax

Edimax IC-5150W Manuale utente

Edimax

Edimax IC-3115W Manuale utente

Asoni

Asoni CAM741H Manuale utente

TRENDnet

TRENDnet TV-IP562WI Manuale utente

Asoni

Asoni CAM628M Manuale utente

TRENDnet

TRENDnet TV-IP762IC Manuale utente

Syscom Video

Syscom Video PT Mini Dome Manuale utente

Samsung

Samsung SND-7080 Manuale utente

Vivotek

Vivotek FE8181 Manuale utente