COBAN GROUP GPS103B Manuale utente
1
GSM/GPRS/GPS Vehicle Tracker
GPS103B User Manual
Preface
Thank you for purchasing the tracker. This manual shows how to operate the
device smoothly and correctly. Make sure to read this manual carefully before
using this product. Please note that specification and information are subject to
changes without prior notice in this manual.
Any change will be integrated in the latest release. The manufacturer assumes
no responsibility for any errors or omissions in this document.
2
Contents
1. Introduction ........................................................................................................................3
2. Hardware Description.........................................................................................................3
3. Accessories Name...............................................................................................................3
4. Specifications......................................................................................................................4
5. Operating Instructions ........................................................................................................5
6. Function setting ..................................................................................................................7
6.1 Initialization.....................................................................................................................7
6.2 Change 123456................................................................................................................7
6.3 Authorization...................................................................................................................8
6.4 Single Tracking ...............................................................................................................8
6.5 Continuous Tracking Automatically...............................................................................8
6.6 LBS Tracking..................................................................................................................9
6.7 Modes switch between “track” & “monitor” ..................................................................9
6.8 Data logging....................................................................................................................9
6.9 Alarms...........................................................................................................................10
6.9.1 Low battery alarm...........................................................................................................10
6.9.2 Power off alarm...............................................................................................................10
6.9.3 GPS blind Spot alarm......................................................................................................10
6.9.4 SOS alarm.......................................................................................................................11
6.9.5 Geo-fence alarm..............................................................................................................11
6.9.6 Movement alarm.............................................................................................................11
6.9.7 Overspeed alarm .............................................................................................................12
6.9.8 ACC working alarm........................................................................................................12
6.9.9 Vibration alarm...............................................................................................................12
6.9.10 Set all alarm mode ........................................................................................................13
6.10 Cut off the Oil and Power System .............................................................................13
6.11 Resume the Oil and Power System............................................................................13
6.12 Arm............................................................................................................................13
6.13 Function of Remote Controller (Option) ...................................................................14
6.14 Disarm........................................................................................................................14
6.15 Silent Mode................................................................................................................15
6.16 Switch between GPRS and SMS Mode.....................................................................15
6.17 Check the Vehicle State.............................................................................................15
6.18 Device Resetting........................................................................................................16
6.19 IMEI Checking...........................................................................................................16
6.20 Time Setting...............................................................................................................17
6.21 TCP/UDP switch........................................................................................................17
6.22 GPRS Setting.............................................................................................................17
6.22.1 Set APN .....................................................................................................................17
6.22.2 Set IP and Port ...........................................................................................................18
6.23 Set up monitor central number...................................................................................18
7. Cautions............................................................................................................................18
8．Faults & the Solutions......................................................................................................19
3
1. Introduction
This tracker is a new product based on the GSM / GPRS network and GPS
satellite positioning system, which set multiple functions of security, positioning,
monitoring surveillance, emergency alarms and tracking in its entirety. It can
track and monitor remote target by SMS or internet.
2. Hardware Description
①. GSM Antenna jack ⑥. USB jack
②. SIM card slot ⑦. External Connection jack
③. SD card slot ⑧. Power/GSM/GPS LED indicator
④. SIM card slot Pop-up switch ⑨. Monitor jack
⑤.GPS Antenna jack ⑩. Remote control receiver antenna
（Option）
3. Accessories Name
4
NO.
PHOTOES
NAME
NOTE
1
GPS Antenna
3 meters
2
GSM Antenna
3 meters
3
Microphone
1.5 meters
4
Power wire
10PIN
5
Relay
12V/40A
8
Remote control
1
4. Specifications
Content
specifications
DIM.
81.8mm x 35.7mm x 60.3mm
Weight
60g
Network
GSM/GPRS
Band
850/900/1800/1900Mhz
GSM/GPRS Module
MT6260A
GPS Module
Ublox7020
GPS Sensitivity
-159dBm
GPS Accuracy
5m
5
GPS Start time
Cold status 45s
Warm status 35s
Hot status 1s
Voltage of car power
system
12 V-24V
Backup battery
Chargeable changeable 3.7V 500mAh Li-ion battery
Storage Temp.
-40°C to +85°C
Operation Temp.
-20°C to +65°C
Humidity
5%--95% non-condensing
5. Operating Instructions
5.1 Terminal Installation
5.1.1 Please ask the qualified engineers to install it.
5.1.2 Do not install it in a environment which is more than GSM performance,
And please pay attention to fix the antennas in a exactly position with good
signals.
5.1.3 Pay attention to make installation location preventing water and dust.
5.1.4 Find the 10 PIN harness and insert it into the corresponding holes of the
products, and connect the wires with the original car circuit showing below:
6
Wiring diagram
5.1.5 Note: The blue wire can be connected to the original car alarm horn;
5.1.6 Know about the type of the door trigger is positive or negative trigger.
Please connect the orange wire to the door control circuit if it is positive, and
connect purple wire if it is negative.
5.1.7 Please install the SOS button on the place driver can touch.
5.1.8 Insert the external monitor Microphone into the monitor jack.
5.1.9 Connected the GPS and GSM antenna to the right jack, and find a
appropriate place and fix the antennas to make sure it receive signals very
well.
5.2 SIM CARD Installations
5.2.1 Use a tweezers or a sharp thing to touch the SIM CARD popup switch, the
SIM CARD slot will pop up, take out the SIM card slot and put SIM card
in it. And then put the SIM card slot back to its original position after
7
confirm the SIM card in the right place.
5.2.2 Please make sure that the SIM card is able to execute the function of
incoming calls display, no calls can be diverted and the PIN code is
locked. The SMS format must be TXT format, and can’t recognize the
PDU format.
5.3 Turn on the Tracker Device.
5.3.1 Connect the positive and negative wire, red and black ones, with 12V or
24V car power system, wait for 1 minute after connecting power to wait
tracker works normal.
6. Function setting
6.1 Initialization
Send SMS “begin+123456” to the unit, it will reply “BEGIN,CONFIG OK ”
and initialize all the settings to default factory settings.（default 123456:
123456）
For example: send SMS “begin123456”, it will reply “BEGIN,CONFIG OK ”.
The “+” in the command, please don’t type “+”, space means press the
space keyboard on your cell phone.
6.2 Change 123456
6.2.1 Send SMS “123456+password+space+new password” to the unit to
change the 123456.
8
For example: send SMS “123456123456 888888” to the unit. If succeeded,
“123456,CONFIG OK” will reply to your cell phone from the device tracker.
6.2.2 Make sure the new 123456 is in 6 digits, or else the tracker cannot
recognize the 123456.
6.3 Authorization
There are 5 numbers to be allowed to authorize in the tracker at most.
6.3.1 Authorization: Send SMS“admin+123456+space+cell phone number” to
set up an authorized number, the other central number should be set by the first
authorized number, if the number is successfully authorized, the unit will reply”
ADMIN,CONFIG OK” by SMS.
6.3.2 Delete authorization: Send SMS“noadmin+123456+space+authorized
number” to delete the authorized number.
6.4 Single Tracking
Make a missed call or send SMS “smslink123456”to device number, it will
reply a real time tracking message include Long & Lat info.
6.5 Continuous Tracking Automatically
6.5.1 Send SMS command “ITV+123456+space+moving time
interval+space+static time interval”to the tracker device.
6.5.2 For example: send SMS “ITV123456 10 500”it will report data to server
9
at 10s time interval when vehicle is moving; 500s time interval when
vehicle is static.
6.6 Cell ID Tracking
6.6.1 You must set up the APN of your local GSM network for the SIM card in
tracker first before using this function, if there is user name and 123456 for
GPRS login, Please refer to following to configure the APN, user name and
123456 for GPRS login.
6.6.2 After configure the APN, send SMS “cell+123456”to device, it will reply
SMS with nearest GSM tower cell ID info. (This function need platform
support )
6.7 Modes switch between “track” & “monitor”
6.7.1 The default mode is “track” (track mode).
6.7.2 Send SMS command "monitor+123456" to tracker device of vehicle
terminal, it will reply "MONITOR,CONFIG OK" and switch to “monitor”
mode. In this mode, the user can dial up the tracker device to monitor the voice.
6.7.3 Send SMS command "tracker+123456" to tracker device of vehicle
terminal, It will return "TRACKER,CONFIG OK" and restore to “track” mode.
6.8 Data logging
6.8.1 Auto logging：When the tracker device lost GSM signals or fall offline
from GPRS, tracker will log the tracking position and alerts automatically in the
10
SD card on the basis of the pre-set condition, when GSM signals get back, all
the event alerts will be auto-sent to the authorized numbers or monitoring
platform (server), but the logged tracking data should be loaded to the
monitoring platform via SMS command. ( Must insert TF card )
6.9 Alarms
Note: All Alarms will be sent to Central Number
6.9.1 Low battery alarm
6.9.1.1 Send SMS “lowbat+123456+space+1”to activate the function, it will
send SMS“low battery+latitude/longitude” to central number when voltage of
battery is below about 3.6V.
6.9.1.2 This function disactivates as default, send SMS “lowbat+
123456+space+0” to deactivate.
6.9.2 Power off alarm
6.9.2.1 Send “extpower+123456+space+1” to activate, it will send SMS
“power alarm+latitude/longtitude” to central number when external power is cut
off.
6.9.2.2 This function disactivates as default. Cancel: Send SMS “extpower+
123456+space+0” to deactivate it.
6.9.3 GPS blind Spot alarm
6.9.3.1 This function disactivates as default, send SMS “gps+
123456+space+1”to activate the function, it will send alert SMS “no gps+last
Indice
Altri manuali COBAN GROUP GPS
COBAN GROUP
COBAN GROUP G509 Manuale utente
COBAN GROUP
COBAN GROUP tk303 Manuale utente
COBAN GROUP
COBAN GROUP TK309 Manuale utente
COBAN GROUP
COBAN GROUP 12000MAH Manuale utente
COBAN GROUP
COBAN GROUP TK-STAR Manuale utente
COBAN GROUP
COBAN GROUP KDL909 Manuale utente
COBAN GROUP
COBAN GROUP G05 Manuale utente
COBAN GROUP
COBAN GROUP TK103A Manuale utente
COBAN GROUP
COBAN GROUP KDL908 Manuale utente
