COBHAM EXPLORER 5075GX Manuale utente

Introduction

This quick guide describes the unpacking and the

assembly of the antenna. On the next page you nd

information how to get on the Internet and how to

download the full user and installation manual.

Assembly

The EXPLORER 5075GX antenna ships from the

factory with pre-set and calibrated position feedback,

limit sensing, limit switches, and motor speeds.

1. Unpack the electronics enclosure with the antenna

positioner.

2. Take the RF assembly out of the case, handle it

carefully.

Do not grab the assembly by the feed horn.

The feed’s subreector can be easily dama-

ged.

3. Place the electronics enclosure upon level ground

and deploy the two support legs.

Do not cover the GNSS (GPS, Glonass, etc.)

module located in the top of the electronics

enclosure.

Do not cover the WLAN module. It sits near

the front of the electronics enclosure.

4. Position the antenna:

Northern hemisphere - The display faces north

Southern hemisphere - The display faces south

High wind conditions: Anchor the tripod to the

ground. Add extra weight to the support legs, or

insert stakes through holes on the support feet.

5. Turn the black knobs to move the feet up and

down to level the base and achieve stability.

6. Retract the two thumbscrews on the mounting

block which are located on the elevation arms.

7. Insert the RF assembly into the mounting block.

8. Tighten the two thumbscrews.

9. Release the four locking mechanisms on the reec-

tor hub on the RF assembly.

10.Unpack the four panels.

11.Insert the two bottom panels and latch them along

the edge of each panel and secure the locking

mechanism at the center hub.

12.Insert and latch the two upper panels and secure

the locking mechanism at the center hub .

EXPLORER 5075GX

Auto-Deploy Fly-Away System for Inmarsat GX

Quick guide

4 5

13.Connect the cables:

BUC power (Gray) cable to MIL connector

Transmit (Red, Tx) cable IFL RG-6 to BUC Transmit port

Receive (Blue, Rx) cable IFL RG-6 to LNB Receive port

Power cable to the electronics enclosure.

Power on

1. Press the On/Off button. The system auto-acquires the

network within ve minutes.

2. When the connection is established, the display shows

ACQUISITION OK.

3. Wait until the eld MDM: in the upper status line shows

NETOK.

Internet

1. Use shielded LAN cables to connect a PC to LAN2, LAN3

or LAN4 for Internet, see documentation from the service

provider.

2. Start a browser.

User & installation manual

You can download the user & installation manual at

www.cobham.com/satcom, Service and Support, COBHAM

SATCOM SERVICE AND SUPPORT, Technical Downloads.

To download the manual from the terminal do as follows:

1. Connect a PC to LAN port 1 (shielded LAN cable).

2. Open an Internet browser and type the address

http://192.168.0.1 (default) to access the web interface.

3. Enter the user name admin and the password 1234

(default).

4. Click HELPDESK and then Support.

5. Click the link Download manual.

98-144074-B

www.cobham.com/satcom

Disclaimer: Any responsibility or liability for loss or damage in connection with the use of this product and the accompanying documentation is disclaimed by Thrane & Thrane A/S. The information in this manual is provided

for information purposes only, is subject to change without notice and may contain errors or inaccuracies. The manuals are periodically revised and updated. Anyone relying on this information should acquire the most current

version e.g. from cobham.com/satcom or from the distributor. Thrane & Thrane A/S is not responsible for the content or accuracy of any translations or reproductions, in whole or in part, of this manual from any other source.