Wireless Door/ Window Sensor
Introduction
Thank you
for choosing the COMAX’s Wireless
is fully compatible with Z-Wave
Every main powered Z-
transmission routes.
This sensor monitors door/window and send
Product Description and Specification
Specification:
Protocol: Z-
Frequency Range: 865.2 Mhz
Operating Range: Up to 50M
Installation
1. Unscrew and open the rear cover.
2.
Using the screws or adhesive tape fix the rear cover on the frame along the opening edge of door /
window.
3.
Insert a CR123A battery into the battery compartment and LED will start to flash slowly, which means the
sensor has not yet been “added”.
4. For addi
ng sensor to a network, Put the Z
add the CM-DW01
meter. Press the program switch of
please try again.
To remove the sensor from a network, Put the Z
instruction to delete the CM-DW01
from your controller. Press the program swit
6.
Fix the Magnet by using the adhesive tape or fixing screws, locate the Magnet close to the
distance between these two devices should be
Operation
1.
Opening the door/window to separate the
will flash once.
2.
Closing the door/window to align the magnet with the sensor will send the
flash once.
3.
Normal operation, the LED will not light.
Operation Manual
Wireless Door/ Window Sensor
CM-DW01
for choosing the COMAX’s Wireless
Door/Window sensor. This sensor is a Z-
as a signal repeater and multiple devices result in more possible
This sensor monitors door/window and send
Z-Wave
signal when door or window is opened and closed.
Product Description and Specification
Frequency Range: 865.2 Mhz
Operating Range: Up to 50M
line of sight
-10°C to 50°C
- 1Pc
Using the screws or adhesive tape fix the rear cover on the frame along the opening edge of door /
Insert a CR123A battery into the battery compartment and LED will start to flash slowly, which means the
ng sensor to a network, Put the Z
-Wave Interface Controller into “
T
he distance between sensor and controller is suggested to be in one
meter. Press the program switch of
CM-DW01 for 1 second. The LED on the sensor
To remove the sensor from a network, Put the Z
-Wave Interface Controller into “
from your controller. Press the program swit
ch of sensor
Fix the Magnet by using the adhesive tape or fixing screws, locate the Magnet close to the
distance between these two devices should be
not more than 1.5cm.
Opening the door/window to separate the
magnet from the sensor will send t
Closing the door/window to align the magnet with the sensor will send the
Normal operation, the LED will not light.
enabled device and
as a signal repeater and multiple devices result in more possible
signal when door or window is opened and closed.
Using the screws or adhesive tape fix the rear cover on the frame along the opening edge of door /
Insert a CR123A battery into the battery compartment and LED will start to flash slowly, which means the
instruction to
he distance between sensor and controller is suggested to be in one
.
-DW01 sensor the
and the LED
and the LED will
