Compass CU2RCSQSD Manuale utente
WARNING – This product contains chemicals known to the State of California to cause cancer, birth
defects and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning,
or otherwise touching this product.
Hubbell Lighting, Inc. Life Safety Products • www.compasslightingproducts.com
© 2018 Hubbell Lighting, Inc., All Rights Reserved • Specications subject to change without notice. • Printed in U.S.A.
COM604057_CU2SQSD_INST_SHT 01/18
LED Emergency Light
CU2RCSQSD
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following.
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. Rated for temperature range of 10℃-40℃ (50℉-104℉) and suitable for use in an
application that is designated as a damp location area as dened by NEC Article 100,
Location, Damp.
2. Used indoors
3. Equipment should be mounted in locations and at heights where it will not be subject to
tampering by unauthorized personnel.
4. Do not mount near gas or electric heaters.
5. The use of accessory equipment is not recommended by the manufacturer and may cause
an unsafe condition.
6. Do not use this equipment for anything other than its intended use.
7. Servicing of this equipment should be performed by qualied personnel.
8. Disconnect AC power before servicing.
IMPORTANT
The battery in this unit may not be fully charged. After electricity is connected to the unit,
let battery charge up to 24 hours. Then the normal operation of this unit should take
effect. To check press the “TEST” button and the lights on the unit should turn ON
RECYCLING INFORMATION
All steel, aluminum and thermoplastic
parts are recyclable. All cartons contain
recycled materials.
Please recycle responsibly.
INSTALLER:
•SEE UNIT LABEL FOR ADDITIONAL MODEL SPECIFICATIONS
•SAVE THESE INSTRUCTIONS FOR USE BY OWNER/OCCUPANT
INSTALLATION
WIRING DIAGRAM
J-Box Mounting
1. Open the Base plate and lead out a wire after getting through the hole on the Base plate. Fix the
Base plate on J-Box with screws.
2. Then connect to AC power (Fig.A).
3. Connect to the battery with connectors (Fig.B).
4. Install the housing to Base plate, turn on the AC power and press the “TEST” button check light
(Fig.C).
Conduit Mounting
1. Secure Base Plate to wall surface. Route wires through hole in conduit ange and make conduit
connection. Use exible conduit only.
2. Connect battery only after continuous AC power is being supplied to the unit (Fig. B)..
3. Align snaps and push housing directly onto the Base Plate (Fig. C). Apply continuous AC power
and press “TEST” button to check light.
OPERATION
1. During an electrical power failure, the lamps on the unit will automatically come ON for a
minimum of 90 minutes.
2. To test this unit, let it charge correctly with AC power supply for a minimum of 24 hours after its
rst installation and then depress the “TEST” switch, the emergency lamps will illuminate. When
the switch is released, the lamps will turn OFF.
3. For the unit with Self-Diagnostic, must connect as below:
1)When customer doesn’t need remote lamp, please insert teminal to N.(See Figure 1 below)
2) When customer needs remote lamp, please insert teminal to Y.( See Figure 2 below)
Figure 1 Figure 2
Warning:
Unused wires must be capped
using enclosed wire nuts.
Indice
Altri manuali Compass Attrezzatura di illuminazione
