CONNECTA HEF644 Manuale utente

Connecta Work Table with Backsplash

Instruction Manual

Models

HEF644 –Worktable with Backsplash 600x600x900

HEF645 –Worktable with Backsplash 900x600x900

HEF646 –Worktable with Backsplash 1200x600x900

HEF647 –Worktable with Backsplash 1500x600x900

HEF648 –Worktable with Backsplash 1800x600x900

Stainless Steel Work Table with backsplash Instruction

A X 1

B X 1

C X 4

D X 8

E X 8

F X 8

G X 1

Safety Tips

⚫Whilst all care has been taken to remove sharp edges, care must be taken when cleaning or handling the table to prevent risk of injury from exposed metal edges.

⚫Do not overload the table top or shelf this may cause it to bend.

Pack Contains

⚫1x Stainless steel top shelf (A)

⚫1x Stainless steel undershelf (B)

⚫4x Stainless Steel Legs (C)

⚫8xMesons (D)

⚫8xMesons (E)

⚫8 x Screws (F)

⚫1x Allen key (G)

Assembly

Note: Be sure to check all packaging materials for any small parts that may have come loose during transportation

1. Remove all packaging including all protective packing material from top shelf, legs and undershelf, taking care to avoid scratching the surfaces.

2. Place the Top shelf down on the floor [A]

3. Insert the legs into the sockets situated at each corner of the top shelf, and insert the screws with mesons (D&E)

Note: Do not secure the legs to the top shelf at this stage. This makes inserting the shelf easier.

4. Position the corner sockets of the undershelf over the four legs.

5. Hold the undershelf in position and insert the screws with mesons(D&E) to loosely secure the undershelf to each leg and the legs to the top shelf.

Note: Leaving the screws loose allows for adjustments to sink shelf and legs.

6. Adjust the shelf and legs so that they are level (use a spirit level if required)

7. Tighten all the screws.

8. Stand the work table upright and remove the remaining protective film.

9. If necessary, adjust the feet to level the sink.

Before using for the first time, it is recommended the table is cleaned thoroughly with a suitable cleaning agent, remove all cleaning residues and dry thoroughly.

Cleaning & Maintenance