%OVERHEAT CONTROL
- is heater is equipped with overheat controls. In case of a malfunction of the unit (blocked
air output or intake, for example) the heater will stop heating automatically. After correcting
the malfunction the heater can be reset.
To restart the heater:
- Turn the heater off and turn its power supply off. Check that the front outlets are free of
obstruction. Wait 5 minutes and turn the heater back on.
If no heat is generated, call your electrician or the nearest CONVECTAIR repair center.
MAINTENANCE
%
&
- To keep your CONVECTAIR unit clean, regular maintenance is suggested. To remove dust,
use a soft cloth. To remove a stain, use a damp cloth. For a better performance and maximum
efficiency, it is suggested that dust and lint be regularly removed from the protective grill
situated at the back of your PICCOLO.
NEVER USE ABRASIVE OR ACETONE-BASED PRODUCTS TO CLEAN YOUR HEATER AS THIS
MAY DETERIORATE THE EPOXY FINISH.
!"#$%&'()$'*)+$&'%"'$',")%&!-
Your CONVECTAIR heater will become hot when in use. Caution is advised when young children are present.
Do not insert small objects in the heater : this could cause an electrical short circuit, fire or damage to the
inner components.
Any use or modifications not approved by CONVECTAIR may cause electrical short circuits, fire or injuries to
the users.
In certain cases, it is possible for yellowing of the surface to occur over time. is is not due to a manufacturing
defect.is is caused by surrounding air, which may contain smoke or dust, being heated and circulated
through the heater.
Prevention : it is suggested that surfaces be frequently cleaned especially with units installed in
locations where cigarette smoke is present or in the kitchen. Never use this heater during construction
work or other activities that generate a lot of dust.
ANY REPAIR ON YOUR CONVECTAIR HEATER SHOULD ONLY BE DONE BY A QUALIFIED TECHNICIAN,
AND ONLY AFTER HEATER HAS BEEN DISCONNECTED.
)*!
