Convoy Extreme Series Guida rapida
Owners/Installaon Manual
IP1910IRHC Extreme Series
Front/Rearview IP Camera
Mounng the Camera
Maintenance
Troubleshoong
Specicaons Warranty and Support Informaon
Convoy Technologies 6409 Highview Drive | Fort Wayne, IN 46818 | Ph (888) 565-2583
1) Select a posion to mount the camera that is free of obstrucons and moving parts and has a proper viewing angle of the de-
sired area around the vehicle.
2) Remove the bracket from the camera by loosening the screws using the supplied allen wrench. Use the camera’s bracket as a
template to drill mounng holes.
3) Align the mounng bracket with pre-drilled holes then secure bracket with appropriate screws. (not supplied)
4) Route camera cable through pass-through hole and secure the grommet.
5) Reinstall the camera using the supplied screws, then adjust to posion.
Although this Rear View Camera requires lile care, you can sll maintain its condion and performance by following these steps:
* Occasionally clean the camera lens with damp so cloth.
Note: The user should not aempt to service the unit beyond that described in the operang instrucons. All other servicing should be referred to
qualied personnel.
Symptoms Soluons
Cloudy Image Clean Dirty Camera Lens
No Power / Image Check Power Connecons
Upside Down Image Camera light sensor should be under the lens.
Unstable Image Check Mounng Hardware and Camera Power Connecon for ghtness
Image Sensor: ⅓” CMOS
Resoluon: 1280*720 /25fps
S/N Rao: ≥50dB
Lens: f=2.8mm 3MP
Lens Angle: Opon 1, (90) 95 x 50
Opon 2 (120) 118 x 65
Cable Length: 1.5m
Video Format: NTSC
IP Rang: IP69K
DC Power: 12V
Operang Temperature: -20° ~ 70° C
Subject to the provisions described below, this CT product is protected for 3
years against defects in material and workmanship. Should a product fail to
perform as described above within the warranted period, it will be repaired or
replaced with the same or funconally equivalent product by CT. This warrant
does not apply if , in the judgement of CT, the product fails due to damage
from shipment, handling, storage, accident, abuse or misuse, or if it has been
used or maintained in a manner not conforming to product manual instruc-
ons, has been modied in any way. Repair by anyone other than CT or an ap-
proved agent will void this warranty. The maximum liability of CT under this
warranty is limited to the purchase price of the product covered by the warran-
ty. All defecve products should be returned to CT with shipping charges pre-
paid. CT will not accept collect shipments.
Owners/Installaon Manual
IP1910IRHC Extreme Series
Front/Rearview IP Camera
Convoy Technologies 6409 Highview Drive | Fort Wayne, IN 46818 | Ph (888) 565-2583
Processor ARM SoC
Image Sensor 1/3 Inch CMOS Digial Image Sensor
TV System NTSC
Image Resoluon/Frame Rate Max:1280*720 /25fps
Lens 2.8 mm HD 3MP Lens
Day & Night Yes
Infrared Nightvision Yes
IR Light 12 pcs
Night Vision Range 20 feet
Lens Angle: Opon 1, (90) H = 95°, V = 50°
Opon 2, (120) H = 118°, V = 65°
Minimum illuminator 0.001Lux @(F1.2,AGC ON),0 LUX with IR
Compression Technology MJPEG
Max Coding Rate 128-8192kbps
Encoding Type CBR or VBR
White Balance Manual / Auto
Gamma Adjusng 0.45
R/N Rao More than 50db
Image intensicaon Brightness, Contrast, Saturaon adjustable
Video Orientaon Le & Right Mirror, Up & down Flip
Network Port EN50155 Ethernet(10M/100M Base-T) M12 connector
Power Input Deutch - DTM04-2P connector
Soware management Windows based Soware Tools
Operang Enviroment -5°C~70°C / -30°C~70°C with heat chip
Voltage DC12/24V Power consumpon lower than 2W
Dimension 110(W) x77(D) x75(H)mm
Video Protocol RTSP over TCP
Waterproof Rang IP69K
Default IP address 192.168.128.10
Owners/Installaon Manual
IP1910IRHC Extreme Series
Front/Rearview IP Camera
Convoy Technologies 6409 Highview Drive | Fort Wayne, IN 46818 | Ph (888) 565-2583
1. System Requirement for PC is Microso Windows 7 /8 /8.1 / 10.
2. Go to PC Network Sengs, Ethernet, Change Adaptor Sengs, Right Click on Ethernet, select
Fig: Acceptable IP addresses that can be used are 192.168.128.2 to 253 (except 192.168.128.10,
which is the stac default IP address of the camera you are trying to view) Note: Do not change
the sengs to the WiFi card, these instrucons apply only to the Ethernet (hard connected)
card.
3. Connect 12VDC ONLY power to camera along with camera M12 connector to an RJ45 Ethernet
directly to your Microso Windows PC. (adaptor for M12 to RJ45 conversion oponal)
4. Launch IP Cong Soware once camera is connected.
5. Camera IP_Address (192.168.128.10) will be detected, Click on Connect to show camera image.
Instrucons to View Camera on Computer
255
192 168 1 1
Owners/Installaon Manual
IP1910IRHC Extreme Series
Front/Rearview IP Camera
Convoy Technologies 6409 Highview Drive | Fort Wayne, IN 46818 | Ph (888) 565-2583
Cables needed to view and program the camera:
M12-4pin F to RJ45 M—connects directly to the ethernet card in your computer
When connecng mulple cameras to an M12 ethernet switch:
M12-4pin F to M12-4pin M extension—connects each camera to the switch
M12-4pin M to RJ45 M—connects the switch to the computer
Each camera will need a unique IP address, which you can change one at a me with the IP Con-
g soware. Once changed, you will need to manually power cycle that camera.
Instrucons to View Camera on Computer
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Convoy Telecamera di sicurezza
